1) deviated stress
偏压应力
2) compressive offset stress
抗压偏移应力
3) deviatoric stress
偏应力
1.
Taking the hydrostatic pressure together with the deviatoric stress into consideration, the critical criterions of phase transformation have been established for “stress induced” and “strain induced” phase transitions.
同时考虑静水压力和偏应力的影响,分别建立了“应力诱发”和“形变诱发”相变的临界准则。
2.
Cyclic triaxial tests are conducted on saturated sand in drained condition with cyclic loading and unloading of deviatoric stress and constant spherical stress.
在固结排水条件下保持球应力不变,进行了偏应力往返作用下的动三轴试验,分析了饱和砂土的体积变形特性。
3.
The test results show that the soil-water characteristic curve is dependent on deviatoric stress.
用净平均应力和吸力等于常数、偏应力增大的三轴排水剪切试验,探讨了剪切对非饱和土水量变化的影响。
4) deviation stress
应力偏量
1.
Comparing with these viscoelastic strain increment expressions,it is concluded that for linear viscoelastic model,if the viscoelastic deformation law under different stress states,such as stress tensor,deviation stress and bulk stress,are the same,their parameters yield as Ek/ηk=Gsk/ηsk=Kmk/ηmk.
对不同应力分量下的广义开尔文模型应力应变关系进行了研究,推导了在不同应力分量下的广义开尔文模型的粘性应变增量计算式;通过对这些粘性应变增量计算式的比较分析,得到结论:对于线性粘弹性模型,当应力张量引起粘性变形的规律与应力偏量和球应力分别引起粘性变形的规律相同时,它们的系数满足关系式Ek/ηk=Gsk/ηsk=Kmk/ηmk;否则,这个关系式不成立。
2.
The viscoelastic deformation law caused by deviation stress is the same as the bulk stress s viscoelastic deformation law when the viscoelastic deformation FEM formula is expressed by stress tensor in existing documents.
现有文献采用应力张量表示的粘性变形有限元计算式隐含假定了球应力与应力偏量产生的粘性变形规律相同,对于复杂的工程材料而言,这种假定并不总是合适的,这在工程问题粘性分析时值得注意。
5) static deviator stress
静偏应力
1.
Study on effect of traffic loading induced static deviator stress on undrained cyclic properties of saturated soft clay;
交通荷载引起的静偏应力对饱和软黏土不排水循环性状影响的试验研究
2.
Effect of traffic loading induced static deviator stress on deformation of saturated soft clay
交通荷载引起的静偏应力对饱和软粘土变形影响
3.
Thirdly,based on the influence laws,a method for confirming the dynamic stress without static deviator stress is put forward.
根据稳定型累积塑性应变发展曲线特点,提出了饱和软黏土的稳定累积塑性应变方程,并通过试验结果分析了该方程中各拟合参数与动应力幅值、固结围压和静偏应力的变化规律,同时提出了求解无静偏应力条件下软黏土临界动应力的解析方法。
6) deviator stress
偏应力
1.
The first set of tests was that mean stress p was constant while deviator stress q changed; the second set of tests was that q was constant while p changed.
做了2种应力路径下的三轴排水剪切试验:平均应力等于常数、偏应力变化的剪切试验以及偏应力等于常数、平均应力变化的剪切试验。
补充资料:轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条