1) turning wheel interval
转轮间隙
1.
The paper gives the treatment measures for correcting turning wheel interval through adjusting pad under the bearing base according to the changes of turning wheel interval in install and debug for horizontal hydraulic turbine in the Power Station of BaiShanQuJiaYeng.
针对白山曲家营电站卧式水轮机安装调试过程中转轮间隙发生的变化,提出通过对轴承座下方垫片的调整,修正转轮间隙的处理方法。
2) steering wheel tilting
转向轮隙
3) flange clearance
轮缘间隙
1.
The flange clearance leakage flow and the pressure of vane surface as well as the streamline distribution laws in the case of different cam industrial operation conditions are obtained via the numerical simulation of leakage flow of different flange clearances of the bulb tubular turbine under the different conditions of industrial operation.
通过对灯泡贯流式水轮机在不同工况、不同轮缘间隙的泄漏流动进行数值模拟,得到了不同协联工况下轮缘间隙泄漏流动和叶片表面的压力及流线的分布规律。
2.
Based on N-S equation,k-ε turbulence model,unstructured grid and clumpy gridding technology,the method of calculating unitedly the guide vane and runner was introduced,flow on flange clearance at 0,0.
本文基于N-S方程和k-ε湍流模型、非结构化网格和多块网格技术,采用导叶和转轮部分联合计算的方法,在不同工况下,对贯流式水轮机模型转轮轮缘间隙在0、0。
3.
The paper expounds pressure distribution of the runner blade which is influenced under the leak flow in the flange clearance region.
基于 Navier-Stokes 方程和标准 k-ε紊流模型,数值模拟轴流转桨式水轮机在含轮缘间隙时转轮内部的流场分布情况。
6) cam clearance
凸轮间隙
补充资料：闭锁间隙
闭锁间隙----又叫弹低间隙。武器闭锁后，当枪机与机匣上的闭锁支撑面紧贴，枪弹以斜肩或底沿与枪管紧贴时，枪弹底面与枪机弹底窝平面之间的距离称为弹底间隙。若枪弹底平面与枪机弹底窝平面紧贴，则枪机匣上的闭锁支撑面之间的距离称为闭锁间隙。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条