1) rolling thread objection
绕线缺陷
2) winding flaw
缠绕缺陷
1.
In this paper, the test and diagnosis of the winding flaws of guidance fiber is researched.
而本文正是在国防项目基础上展开的,主要对制导光纤缠绕缺陷测试诊断做了相应的研究。
3) linear defect
线缺陷
1.
It is shown that adding the third material as point defect/linear defects in the two-component PC, defect states/bands can appear in the original band gap whose position and width would have only minor changes.
结果表明,二组元声子晶体在引入第三组元点缺陷/线缺陷后,在原来的带结构中会出现缺陷态/带,原带隙的位置、宽度变化不大;缺陷态/带频率主要受第三组元材料物性参数的影响;这些缺陷态都是局域化的。
4) line defect
线形缺陷
1.
The inner spiral copper tube produced by extrusion-rolling process has a kind of special line defect,which influences the production yield remarkably.
采用挤轧法生产内螺纹铜管时易出现一种特有的线形缺陷,显著影响内螺纹铜管的成材率。
5) line defect
线缺陷
1.
The photonic crystal waveguide is constructed by introducing a line defect into the photonic crystal composed of squre air cylinders embedded in square lattice.
而加大线缺陷的宽度可以使能量衰减较为缓慢,所以也可以加大能量传播范围。
2.
The simulation results show that one-to-two beam splitter, deflector and one-to-three beam splitter can be realized by appropriately arranging the line defect along the proper direction.
数值计算表明,通过在合适的方向引入不同的线缺陷,可以实现自准直光束的1×2和1×3分束以及光束偏转。
6) linear defect
线状缺陷
1.
Causes of linear defects on the surface of cold-rolled sheet:analysis and discussion
冷轧板表面线状缺陷成因分析与探讨
2.
The surface linear defects of 45# steel bolts have been analyzed by macrostructure examination,metallography and electron probe micro-analyzer.
针对45#钢螺栓表面线状缺陷进行了低倍、金相、电子探针等检测分析,结果表明,线状缺陷由大型夹渣造成,其主要成分为SiO2、CaO、Al2O3、Na2O,系连铸过程中酸性钢水中包覆盖剂卷入所致。
补充资料：点缺陷(见晶体缺陷)
点缺陷(见晶体缺陷)
point defect
点缺陷point defeet见晶体缺陷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条