In this paper we discuss the methods of analysis and calculation of the technical parameters (working pressure and test speed) about test system by power recovery for the large power hydraulic motors or pumps, and propose available ideas which should be adopted during test parameters.

Complete technology and equipment for sintering batch test in steel plants;

Control of Over-test and Short-test in Shock Spectrum;

The test of Φ610×12.7mm UOE welding tube X60 pipeling steel;

Industrial Experiment of Blast Furnace Operation with Proportion of Rio Tinto Mixed Lump Ore at Meigang;

Saccharification Experiment for Extrusion Cooked Wheat Used as Beer Adjunct;

Design and Experiment of Welding with Trailing Peening System Based on Electromagnetism Control;

A trial on the health education intervention of the community residents;

Preliminary study on advanced trial for new cassava breeding lines;

Comparison and analysis of the results of pile skin friction by dynamic and static load tests;

Design, modal analysis and tests of composites wing box;

Study on primary system tests of Large Unit of Generator-transformer Bank Protection;

Development of experiment system for parker performance testing in high temperature;

Design and Testing of Technological Process for End-upsetting of Oil Drill Pipe;

Testing Concerning Process of Threading Non-CoupledEnd of Coupled Tubing;