1) minimum sintering temperature
最小粘结温度
1.
When the temperature of the fluidized bed was lower than the minimum sintering temperature (T s),the minimum fluidization velocity of sintering material,belonging to Ge.
结果表明 ,在本文实验条件下 ,Geldart A、B类高温表面粘结物料 ,床层温度小于其最小粘结温度时 ,床层温度增大 ,颗粒的最小流化速度减小 ;Geldart D类高温表面粘结物料的最小流化速度随温度增加而增大。
2) sticking temperature
粘结温度
3) maximum viscosity temperature
最高粘度温度
4) minimal mucus film thickness
最小粘液膜厚度
1.
Based on the finite difference method,the relationship between the characteristic parameters and kinetic properties such as the minimal mucus film thickness and the axial thrust force was analyzed theoretically.
采用有限差分法分析了内窥镜机器人各特性参数对机器人形成的最小粘液膜厚度和轴向牵引力的影响,从而获得当需要较厚的粘液膜厚度和较大的轴向驱动力时最优的机器人特性参数,进一步为机器人更好地以较厚的粘液膜厚度和较快的速度悬浮式运行创造条件。
2.
The influences of parameters of this micro-robot on the generated axial thrust force and minimal mucus film thickness are analyzed theoretically.
提出了一种新型可进入人体内腔和血管的医用微型机器人,理论分析研究了各参数对该机器人轴向牵引力和最小粘液膜厚度的影响,从而为该机器人在内腔和血管中快速地悬浮式运行创造条件。
5) lowest non-freezing temperature
最低不结冰温度
1.
Experimentally studies the effect of magnetization on the lowest non-freezing temperature of water using the high-effective multi-functional magnetizer,and finds that the freezing point of magnetization water declines about 1 ℃,which is helpful for enhancing the energy storage efficiency of supercooled water,increasing the economic benefit of a cold storage system and saving energy.
通过采用高效多用途磁化器使水磁化,实验研究了磁化对水的最低不结冰温度的影响,发现磁化后水的结冰温度降低1℃左右,有利于提高过冷水蓄能效率、增加蓄冷系统经济效益和节约能源。
6) minimal bond-anchorage length
最小粘贴锚固长度
补充资料：最小辐亮度与最小辐照度(见核爆炸火球)
最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance
zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条