1) egg-arch section
卵形(蛋拱状)断面
2) vaulted section
拱形断面
1.
In order to apply the traditional numerical method to approximately calculate heat and moistness load, thedesigners often change the vaulted section of the Underground Engineering to rectangular section with the same perimeter.
本文采取大型通用有限元分析软件ANSYS对原模型和简化模型进行瞬态热分析,分别对等周长的拱形断面或长方形断面采取等单元密度划分,在两个断面上分别形成间距相同的206个节点,通过不同时间点断面上间距相同的18个节点的平均温度及断面瞬时传热量的比较,判断简化模型的精度。
3) circular arch section
圆拱状断面
1.
The author,with his practice in his long working time ,discover some blemish in the tra-ditional way of analysis on arch supporting force of tunnel with circular arch section.
笔者在长期的工程实践中发现,传统的圆拱状断面隧道承压能力分析方法有一定的缺陷,圆拱状断面隧道拱壁支承力的传递有一定的规律可循。
4) egg surface
蛋形面，卵形面
5) cross-section shape
断面形状
1.
SuperForm,the effect of friction on cross-section shape of workpiece in grooveless rolling is analyzed.
Superform研究了无孔型轧制过程中摩擦条件对轧件断面形状的影响,分析表明:轧件自由宽展面和角部的变形与摩擦条件有紧密的关系,尤其在大压下量的轧制状况下其影响更为显著。
2.
This paper aims at examining the influences of spatial variability of furrow sole fluctuation and cross-section shape on furrow irrigation performance.
针对沟灌,研究了沟底起伏状况和沟横断面形状的空间变异性对灌水质量的影响。
3.
So the circular cross-section and curved wall cross-section are practicable tunnel cross-section shapes,rectangular cross-section and straight wall arch cross-section are not.
采用FLAC3D软件分析了圆形断面、矩形断面、直墙式断面和曲墙式断面形状隧道开挖在III级围岩中的位移和应力集中分布规律。
6) Section form
断面形状
1.
The optimization process of the section form and lining of the twin tunnel is expounded in this text with an engineering example-Bai Yang chong No.
本文结合具体工程实例—白洋冲一号连拱隧道,阐述了连拱隧道断面形状及衬砌的优化过程。
补充资料：异形断面钢材(见异形断面型材)
异形断面钢材(见异形断面型材)
special section steel
，一、u以uu、’“飞豆on gQngC01异形断面钢材(speeial Seetion steel)见异形断面型材。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条