1)  VAR
容积面积比
1.
Then,the parameters of the optimal VAR in different meteorologic conditions coul.
通过对影响水箱容积与集热面积合理配比取值若干问题的分析 ,提出了应根据设备投资、热水器服务地区的气象条件等因素 ,来考虑太阳能热水器水箱容积与集热面积合理配比取值的观点 ,给出了以最大收益为目标函数的计算公式 ,利用该公式可得到各种气象条件下的最优容积面积比参
2)  cubage
容积
1.
The article stresses the introduction of thermal balancing analysis of oil tank in hydraulic system,and parameter calculation of cubage and area of dissipation.
重点介绍液压系统中油箱的热平衡分析及其容积和散热面积参数的计算。
2.
The method of the software,hardware design and data processing of the chemical fuel tank cubage calibration system are introduced,all the error elements of this system are analyzed.
介绍了一化工燃料贮罐容积标校系统软、硬件设计原理和数据处理方法,对标校系统的各种误差成分进行了分析,并运用实际任务中的数据对贮罐标校系统的成果进行了精度验证,结果表明该系统可以提供比较精确的加注量参数。
3)  volume
容积
1.
Clinical Significance in Volume Measurement of Cholecysts in Chronic Cholecystitis Using 3-D Automatic Techniques;
慢性胆囊炎三维容积测定的临床意义
2.
Experimental research and clinical application on the lower lumbar vertebral canal volume with spiral CT and 3D measure;
下腰椎椎管容积螺旋CT与铸型测量及其临床意义
3.
The Volume Measurement of Ovarian Cystic Masses by Three-Dimensional Ultrasound;
三维超声成像测定卵巢囊性肿瘤容积
4)  Capacity
容积
1.
Expansion Tank of Heat Conduction Oil Capacity and Caculation and Application of Installation Beight in Malic Anhydride;
顺酐装置中导热油膨胀罐容积及安装高度的计算与应用
2.
Direct against the defects of high cost,complicated computation and fixed accuracy of calculation on cabin capacity based on CAD software,a kind of cabin capacity computing method based on nodal point,which stands alone to the CAD system,was realized.
针对基于CAD软件的船舱容量计算成本较高、计算复杂、并且精度固定的缺点,实现了一种独立于CAD系统,基于型值点的舱容算法,用较低的成本,就可以方便快速地计算出船舱中液体的容积。
5)  volumetric loading
容积负荷
1.
8%,and the COD removal had a negative relativity with volumetric loading rate;the average COD of the effluent was 2596 mg/L,but had a poor biodegradability,with an average BOD5/COD ratio of 0.
在进水原生渗滤液COD浓度在17 157~33 599 mg/L时,通过控制进水量,调节停留时间,控制反应器容积负荷在6。
2.
The effects of toxic and harmful matters, alkalinity and volumetric loading on the anaerobic biological treatment were studied and discussed through an experimental comparison between diluted influent water and undiluted influent water.
通过进水稀释与不稀释的实验对比,分析探讨了有毒有害物质、碱度、容积负荷等对厌氧生物处理的影响。
3.
The main objective of the experiments is to study the influence of gas to liquid ratio,hydraulic and influent organic loading,carbon and nitrogen mass ratio and the bed material height on the volumetric loading of BAF operated under lower aeration conditions.
针对南方特有的低浓度生活污水,研究了在低曝气条件下,气水比、水力负荷、进水有机负荷、碳氮比、填料层高度等因素对曝气生物滤池容积负荷的影响。
6)  volume ratio
容积比
1.
Adequate selection of high-low pressure volume ratio of double-stage refrigeration compression system;
合理选择双级制冷压缩的高低压容积比
2.
Therefore,the influence of the volume ratios of anoxic zone to aerobic zone on denitrifying phosphorus removal in the A2/O process for treating brewery wastewater was studied.
为此以啤酒废水为处理对象,研究了缺氧区与好氧区容积比对A2/O工艺反硝化除磷的影响。
3.
Applying the vector representation of formula for definite proportional division point in vector algebra,this paper obtains a new useful method of compunction for segment ratio in volume ratio.
利用向量代数中定比分点公式的向量形式，给出了一种非常简明有用的求容积比中线段比的新方法。
参考词条
补充资料：比表面积
分子式：
CAS号：

性质：单位体积或单位质量固体的表面积，通常用1g固体的总表面积表示。由于制备条件的不同，固体与气相接触的表面大小可有很大差异。多孔性和细碎性固体的表面积包括内表面和外表面，内表面由其内部孔隙和裂缝缝隙面积构成，外表面是固体外部的几何面积，二者之和为总表面积。比表面通常用物理吸附法测定，如BET容量法、重量法、流动色谱法等。有时也可用液相吸附法测定。对比表面大于1m2/g的样品常用低温氮吸附容量法或流动法，而小表面则用低温氪吸附法。对于非孔性固体，也可根据测出的粒子大小计算比表面。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。