1) titanium composite oxides
钛的复合氧化物
1.
The peculiarity of tinbased negative materials,titanium composite oxides,nitride and other noncarbon negative electrode materials for lithium ion battery was discussed.
分别对锡基负极材料 ,钛的复合氧化物 ,过渡金属氮化物及其它锂离子电池非碳负极材料的研究进行了阐述 ,并指出它们各自的特点。
2) TiO2-SiO2 composite oxide
钛硅复合氧化物
1.
The TiO2 and TiO2-SiO2 composite oxide were prepared by Sol-gel method and characterized by XRD,BET and DRS.
用溶胶-凝胶法制备了TiO2和钛硅复合氧化物,对样品进行了X射线衍射(XRD)、比表面积测试(BET)和紫外-可见漫反射光谱(DRS)分析,并以甲基橙为模拟污染物,考察了其光催化性能。
2.
Preparative methods of sol-gel,hydrolysis precipitation,hydrothermal synthesis for photocatalysts of TiO2-SiO2 composite oxide at home and abroad are introduced in this paper.
介绍了溶胶–凝胶法、水解沉淀法、水热合成法制备钛硅复合氧化物光催化剂的研究进展,评述了3种制备方法的优缺点以及添加硅对TiO2光催化活性的影响:添加硅后增大了催化剂的比表面积,提高了TiO2晶型转变温度,增强了其表面酸度,生成的Ti—O—Si键抑制了TiO2粒径的增大,拓宽了催化剂的禁带宽度,从而提高了光催化剂的催化活性。
3) titanium-aluminum bi-oxide
钛铝复合氧化物
4) composite titanium-zirconium oxides
钛锆复合氧化物
1.
Preparation and catalytic properties of composite titanium-zirconium oxides;
钛锆复合氧化物的制备及催化性能的研究
5) titanoniobium composite oxide
钛铌复合氧化物
1.
HTiNbO_5 was pre-expanded by long-chain alkylamine,then reacting with a solution containing Ti(IV) polycations,followed by calcining the obtained precursor in air,two titanoniobium composite oxides(designated as HTNO) with a high specific surface area were prepared.
HTiNbO5经用长链有机胺预支撑,再与含Ti(IV)聚合阳离子溶液反应,所得产物在空气气氛中焙烧后制备出高比表面钛铌复合氧化物。
6) Lithiated titanium composite oxide
锂钛复合氧化物
1.
Lithiated titanium composite oxides Li 4Ti 5O 12 were prepared from Li 2CO 3 and TiO 2.
采用 3种化学方法合成锂钛复合氧化物 。
补充资料：钴钼氢氧化物氧化物磷酸盐
CAS：68130-37-0
中文名称：钴钼氢氧化物氧化物磷酸盐
英文名称：Cobalt molybdenum hydroxide oxide phosphate； Molybdenum cobalt acid phosphate complex； Molybdenumcobaltacid phosphate complex
中文名称：钴钼氢氧化物氧化物磷酸盐
英文名称：Cobalt molybdenum hydroxide oxide phosphate； Molybdenum cobalt acid phosphate complex； Molybdenumcobaltacid phosphate complex
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条