1) dead-time voltage
死区电压
1.
The results of MATLAB simulation show that the controller can overcome the dead-time voltage and has a better dynamic performance.
3 V的抖动更利于克服舵机的死区电压。
2) dead voltage vector
死区电压矢量
1.
During a modulation period,several dead voltage vectors were synthesized.
在一个调制周期内,可预先求出几个死区电压矢量的合成矢量,用控制软件的方法实现对参考空间电压矢量的校正,从而消除死区效应。
3) dead-time disturbance voltage vector
死区扰动电压矢量
1.
With the proposed method, the dead-time disturbance voltage vector rotates synchronously with current vector and no longer depends on current direction.
这种情况下,死区扰动电压矢量在d-q坐标系下的分量可由id和iq算得,死区补偿不再需要检测电流方向,这就避免了传统的补偿算法在相电流处于零附近时由于电流方向检测的不准而使得补偿效果下降。
4) Dead time control circuit
死区电路
5) dead voltage
死电压
1.
The concept of dead voltage of MCP with film was discussed.
给出了半视场对比测试结果、死电压概念、死电压曲线、死电压与膜厚关系曲线 ;最后给出了采用XPS进行成分分析的结果。
6) Unelected section
"压不死"区段
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条