1) water-binder ratio
胶比
2) gluing ratio
施胶比
1.
Research on auto-control modes of particle board gluing ratio;
刨花板施胶比自动控制模式研究
3) water binder ratio
水胶比
1.
For water binder ratio 0.
目的研究不同粉煤灰的掺量和不同水胶比条件下粉煤灰混凝土的绝热温升和胶凝材料水化速率的发展规律。
2.
By using drying and wetting cycles in water and sulfate solution,the effects of several factors on the resistance to sulfate attack of lightweight aggregate concrete were studied,the factors include:water binder ratio,air-entrained agent,content of fly ash and lightweight aggregate.
采用在水中和硫酸盐溶液中立浸并进行干湿循环的试验方法,分析讨论了水胶比、引气剂掺量、粉煤灰掺量及轻集料对轻集料混凝土抗硫酸盐侵蚀性能影响的规律。
4) water to binder ratio
水胶比
1.
The effect of water to binder ratio (w/b) and fly ash type on fly ash-saturation was investigated under full hydration condition in mortar system.
并结合实验探讨了充分水化条件下,水胶比、粉煤灰种类等因素对砂浆体系中粉煤灰最佳掺量的影响规律。
2.
The influence of water to binder ratio(W/B) and fly ash addition together on the autogenous shrinkage of concrete was experimentally studied under the condition of that the compressive strength at 7 day were the same.
在保持混凝土7d抗压强度不变的条件下,研究了水胶比和粉煤灰掺量变化对混凝土的自收缩的综合影响。
3.
The effect of densified silica fume on low workability concretes under different water to binder ratio was studied.
在不同的水胶比条件下,考察了凝聚态硅灰对低工作性混凝土强度发展历程的影响。
5) water-binder ratio
水胶比
1.
Effect of water-binder ratio and composition on the hydration products and hydration degree of complex shrinkage-compensating binders;
水胶比和组成对补偿收缩胶凝材料水化程度与水化产物的影响
2.
Effects of water-binder ratio and blending volume of ultra-fine fly ash on bondability in high performance concrete;
水胶比及超细粉煤灰掺量对高性能混凝土钢筋握裹力的影响
3.
The effects of water-binder ratio,content of fly ash,type of fly ash,and curing time on strength of mortar.
试验研究了水胶比,粉煤灰掺量,粉煤灰种类和龄期等因素对砂浆强度的影响;分析了砂浆强度与粉煤灰掺量之间的相互关系,以确定最佳水胶比和粉煤灰掺量。
6) Crystal/gel ratio
晶胶比
参考词条
补充资料：胶银比
分子式：
CAS号：
性质：指感光乳剂制备过程中各阶段用胶的总量与含银量的比值。它是乳剂制备过程中一个重要的控制因素。胶银比对乳剂颗粒的大小、卤化银微晶的结构、乳剂的感光特性、乳剂涂层的厚度、显影的速度以及解像力等都有重要影响。胶银比小，可实现薄层涂布，减少乳剂层的吸水膨胀性，有利于加快显影速度和提高解像力；但胶银比太小，则会降低对卤化银颗粒的保护作用，使黏度下降，影响涂布质量，容易产生摩擦灰雾。一般感光材料的胶银比为2:1至3:2左右。
CAS号：
性质：指感光乳剂制备过程中各阶段用胶的总量与含银量的比值。它是乳剂制备过程中一个重要的控制因素。胶银比对乳剂颗粒的大小、卤化银微晶的结构、乳剂的感光特性、乳剂涂层的厚度、显影的速度以及解像力等都有重要影响。胶银比小，可实现薄层涂布，减少乳剂层的吸水膨胀性，有利于加快显影速度和提高解像力；但胶银比太小，则会降低对卤化银颗粒的保护作用，使黏度下降，影响涂布质量，容易产生摩擦灰雾。一般感光材料的胶银比为2:1至3:2左右。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。