1) microelectromechanical sysem
临界吸合电压
2) critical voltage
临界电压
1.
Three-dimensional analysis of the static voltage stability and the critical voltage in power system;
电力系统静态电压稳定的三维分析与临界电压
2.
Based on this,the critical voltage and the critical energy value of load node before and after compensation are successfully computed through adopting the preserving nonlinear flow algorithm(PNFA) integrating the optimal multiplier.
在此基础上,通过引入优化乘子的保留非线性潮流法(preserving nonlinear flow algorithm,PNFA)计算得到的系统各负荷节点临界电压来求取其补偿前后的临界能量值,然后根据各临界能量值得到补偿前后系统的无功裕度,并分析电容器并联补偿对系统电压稳定的影响及补偿前后无功负荷比例增长时各节点电压相角、负荷节点需耗能量值的变化趋势。
3.
It also presents us the counting method of critical voltage and maximun active power in stable running system,and analyses the influence of load on voltage stability in power system.
根据系统等效的方法 ,建立了电力系统任一节点电压与有功功率、无功功率的数学模型及对应的特性曲线 ,给出了系统稳定运行临界电压和极限有功功率的计算方法 ,分析了负荷对电力系统电压稳定性的影响 ,提出了提高电力系统电压稳定性应采取的有效措施 。
3) pull-in voltage
临界电压
1.
At the same time, the results reveal the relationship that the period of response is proportional to the driving voltage, and the character that dynamic pull-in voltage is.
同时也揭示了微梁振动响应周期与驱动电压成正比、动态临界电压低于静态临界电压等相关特性。
4) critical withstand voltage
临界耐电压
5) critical voltage difference
临界电压差
6) critical desorption pressure
临界解吸压力
1.
Analyses data as average methane content, saturation, critical desorption pressure and theoretical recovery in the main coal reservoirs as well as desorption rate and desorptionable volume of coal bed methane(CBM).
分析了潞安 -晋城 (新区 )矿区主煤储层的平均含气量、饱和度、临界解吸压力、理论采收率以及煤层甲烷解吸率、可解吸量等数据 ,得出本区主煤储层平均解吸率约为 37% ,高于全国其它地
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条