1) wave infiltration
比值滤法法
2) ratio method
比值法
1.
Source identification and apportiontment of PAHs was processed by both ratio method and CMB receptor model for the inhalable particulates (PM_(10((.
研究了北京市2000年采暖期和非采暖期2个典型代表月(6月和12月)不同粒径颗粒物的质量浓度特征以及不同粒径颗粒物中ρ(PAHs)分布特征,并同时利用比值法和化学质量平衡(CMB)受体模型对可吸入颗粒物(PM10)中PAHs的来源进行识别和解析。
2.
This paper analyzes the cause of poor shows basing on the oil-bearing characteristics of Indonesia block and the time delay property of operation, illustrates the theory of identifying this type of reservoirs using hydrocarbon ratio method, and proposes ratio method and profile.
通过对印尼区块的含油特点和操作上的延时性分析了显示较低的原因,阐明了烃类比值法识别这类储集层的理论,提出了地化录井识别和评价这类储集层的方法———比值法和剖面法,有效地解决了该类地层解释符合率较低的问题。
3.
Taking into account the efficiency of the rough set in incomplete information processing, the intuitiveness of querying and matching by case-based reasoning and the convenience of the ratio method, an approach based on multi-artificial intelligence methods for diagnosing transformer faults is proposed.
鉴于粗糙集处理不完备信息的有效性、范例推理查询匹配的直观性以及比值法的简洁性,提出了基于多种智能方法的变压器故障综合诊断方法。
3) difference ratio
差比值法
1.
Application of difference ratio of equivalent elastic modulus in identifying low resistivity hydrocarbon layers;
等效弹性模量差比值法在识别低阻油气层中的应用
4) Hydrocarbon Ratio Technique
烃比值法
5) three-ratio
三比值法
1.
This new diagnosis method expand coding bound of original IEC three-ratio.
针对IEEE三比值法对油浸式变压器故障诊断的缺码和多种故障发生时的难诊断现象,建立标准故障序列,利用灰色关联度原理判断故障气体与标准序列的关联程度,根据模糊熵的原理计算故障气体与标准模型的相对熵,相对熵最小的标准序列即为变压器的绝缘故障。
6) Three-ratio method
三比值法
1.
This paper deals with using DGA for fault diagnosis of transformer devices, introduces the basic theories of characteristic gas method, three-ratio method and Duval s triangle method, and further points out the indispersability of building DGA data base through practical examples.
本文叙述了油中气体分析在变压器类设备故障诊断中的应用,介绍了特征气体法、三比值法和三角形法的基本原理。
2.
Based on analyzing oil chromatogram data,using the ultrasonic method to test the position of partial discharge ,the electrification monitoring technology and three-ratio method,the fault reason of a light gas pressure protection actuation on the main transformer are analyzed.
针对一起主变轻瓦斯动作故障,在油色谱数据分析的基础上,利用局部放电超声波定位、带电监测技术和三比值法对故障原因进行了分析论证。
3.
Fuzzy C-means clustering(FCM) algorithm,BP neural network,rough set theory diagnosis algorithm and IEC 60599 recommended three-ratio method are adopted as monomial methods to diagnose fault independently in the new diagnosis model.
该方法采用模糊C均值聚类(FCM)诊断法、BP神经网络诊断法、粗糙集理论故障诊断法和IEC 60599推荐的三比值法这4种诊断方法作为独立的单项诊断方法,根据各自诊断的误判率,按照诊断误差平方和最小的原则计算出各个诊断方法的最优权重,形成最优投票组合模型,再求出最大发生概率的故障类型。
补充资料:X线滤线栅比值
X线滤线栅比值
放射学术语。又称栅比。系滤线铅条高度与其间隔距离的比值。栅比值影响滤线栅吸收散射线的效能,二者呈正比关系,而摄影条件的增幅也随之加大。栅比值的设置范围一般是4~16。实际应用中,栅比不宜过大,多为6∶1和8∶1。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条