1) quality failure
质量失误
1.
Study of contract-making strategy in the supply chain considering quality failure;
考虑质量失误的供应链合同制定策略研究
2.
The efficient coordination between one risk neutral supplier and one risk neutral buyer was studied in view of products quality failure.
在理性的制造商和供应商组成的二级供应链中,考虑存在产品质量失误的情况下,通过最优化方法选择中间品的质量水平和制造商的检测水平,以实现供应链的利润最大化。
3.
This paper presents a game model between the supplier and the buyer which are the two parts of the bilevel supply chain,and presents a theorem illustrating that there exists an optimal solution of the quatity level and delivery delaying probability as well as corresponding penalty on the supposition that both quality failure and delivery delaying exist.
本文考虑在存在质量失误与延期交货问题的情形下,两层次供应链中供应商和制造商的博弈关系模型,证明了最优解以及相应罚金的存在性,并分析了质量水平、延期交货与罚金之间的关系。
4) mass loss
质量损失
1.
Internal gas mass loss analysis of inflatable space antenna reflector subjected to impact;
空间充气天线反射器受冲击气体质量损失分析
2.
Calculation of internal insulation ablation mass loss of solid rocket motor;
固体火箭发动机内绝热层烧蚀质量损失计算
3.
Investigation of mass loss regulation of Li-ion battery;
锂离子电池标准中质量损失问题的研究
5) quality loss
质量损失
1.
Robust tolerance design based on fuzzy quality loss;
基于模糊质量损失的公差稳健设计方法的研究
2.
Tolerance design of products with correlated characteristics based on current value of quality loss
基于现值质量损失的相关特征产品的公差设计
3.
In terms of given manufacture process planning, signal-noise ratio (SNR) was employed to scale quality loss of each process.
针对加工工艺规划,提出采用信噪比衡量各道工序对产品质量损失的影响。
6) weight loss
质量损失
1.
In case that the coal is mixed with mineral matter, an analysis was carried out under this condition, on both weight loss of various samples at a different temperature and first order of the weight loss by use of heat weight balance TGA-601.
利用热重天平TGA-601分析了各种样品在不同温度时的质量损失及质量损失一阶导数。
2.
By strength and weight loss analysis of concrete after freeze-thaw cycle,it is pointed out that there is not obvious improvement of polypropylene fiber to weight loss of lightweight concrete,however,it can improve concrete strength.
通过对冻融循环后混凝土的强度和质量损失分析,指出聚丙烯纤维的掺入对轻骨料混凝土质量损失改善作用并不明显,但可以提高混凝土强度。
3.
On the contrary,the weight loss rates of cotton stalks treated with NaCl,MgCl2,KCl or ZnCl2 was increased.
碱性催化剂K2CO3、KOH降低了棉花秸秆的最大质量损失率,而KCl、NaCl、MgCl2和ZnCl2却增大了棉花秸秆的最大质量损失率。
补充资料：蚕茧质量监督检查和国家生丝质量检验
蚕茧质量监督检查和国家生丝质量检验
cocoon quality supervision inspection and national silk quality inspection
检验局承担并组织有关检验机构对全国已核发生产准产证的缘丝、绢纺企业的生丝、绢丝质量进行抽查检验(两年共四期)，以考核生产企业生丝质量水平。中国桑蚕鲜茧评茧计价方法主要有3种:①鲜上光茧干壳量仪器评定(简称仪评)计价;②“组合售茧、嫌丝计价，’(简称“组、缎”)评茧方法;③茧层率评茧计价。国家质量技术监督局于19望)年6月7日下发了《关于加强茧丝质t监督工作的通知》，要求加强桑蚕鲜茧收购期间的质量监督执法检查;重点做好鲜茧收购过程中“四率”(仪器配备率、仪器完好率、仪评率和仪评相符率)的检查工作。各级专业纤维检验机构应充分发挥职能作用，加强蚕茧质量监督管理;加强对茧站仪评计价工作指导;加强对蚕茧收购计t器具的检定工作;充分运用法律手段，在蚕茧收购期间开展执法检查活动，对违法行为坚决予以查处。 在国家生丝质t检验方面，1998年国家经贸委等4部门联合发布了(缀丝绢纺准产证制度实施办法》，规定缎丝、绢纺企业准产的基本条件。经国家茧丝绸协调小组审议，并报国务院领导批准，“国家生丝质量检验”项目列人(国家茧丝绷发展风险基金》第二批发展项目。该项目由中国纤维检验局承担并组织依法设t或依法授权的具有生丝、绢丝检验能力的纤检局(所)、生丝质检站对全国已核发生产准产证的缀丝、绢丝企业的生丝、绢丝质量进行检验。(吕善模)，ngconjian zhilia叩Jiondu iianCha he gUOJia she叩51 zh1旧nyan蚕茧质一监督检查和国家生丝质t检验coon甲ality su伴币sion inspection and natsilk卿ality ins衅tion)专业纤维检验机构蚕鲜茧收购期间，对茧站收购鲜茧进行质量监督和检验的全过程。国家生丝质量检验是指由中国CO-nal桑查维
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条