1) AC V-I characteristics
交流伏安特性
1.
Through the analysis of MOA AC V-I characteristics, it is found that with voltage increasing, the harmonic contents of resistive current is increasing bigger than that of first-harmonic, and the increasing of the magnitude of first-harmonic is well-proportioned.
对MOA交流伏安特性进行分析,发现随着电压升高,阻性电流谐波分量增长幅度明显比基波分量增长幅度大,但阻性电流基波分量增长稳定。
2) V-I characteristics in leakage current region
小电流伏安特性
3) ac volt
交流伏特
4) current-voltage characteristic
电流-电压特性，安-伏特性
5) volt-ampere characteristic
伏安特性
1.
The volt-ampere characteristics deciding the electric arc power,which affect the fusion of the spraying powder and then influence the quality of coatings,are affected by many factors including gas species,gas flow rates,the nozzle's aperture and compression angle.
等离子弧的伏安特性决定电弧功率的大小,从而影响喷涂粒子的熔融状态,进而影响了涂层的质量。
2.
The volt-ampere characteristics of aluminum's high voltage anodization were studied in four different electrolyte systems.
对铝在4种不同电解液体系中的高压阳极氧化的伏安特性进行了讨论。
3.
By using computer and high-speed data acquisition card PCI-1711 which is based on the PCI bus,a new model of measuring system for PTCR s volt-ampere characteristic was built up.
利用PC机和基于PCI总线的高速数据采集卡PCI-1711,开发出了新型PTCR伏安特性测试系统。
6) current-voltage characteristics
伏安特性
1.
To increase the discharge energy density and the discharge stability,this paper proposed a method of bipolar corona discharge in needle-matrix electrode configuration,and investigated the current-voltage characteristics of bipolar corona discharge in Multi-Needle Electrode Configuration.
为提高电晕放电的能量密度和放电稳定性,提出了针阵列电极结构的双极电晕放电方式并研究了多针电极结构双极电晕放电的伏安特性。
2.
The influences of polarity of discharge electrode,spacing between needles,and spacing of needle and plate,on the current-voltage characteristics of multi-needle-to-plate corona discharge are experimentally researched.
实验研究了多针对板电晕放电的放电极性、尖板间距D的变化对伏安特性的影响,近似算得其伏安关系式I=CU(U-US)并确定了正、负电晕放电中的C值,由C与D的关系得出随D的减小,放电功率和电流密度增加的结论,在一定条件下实验结果与推导得到的伏安关系式吻合。
3.
This paper reports a new circuit for measuring the current-voltage characteristics of diodes, which adopts a current-modeling circuit, in which the current is taken as a signal variable.
本文报导了一种新的用于测量非线性元件伏安特性的实验电路,该电路采用的是以电流为信号变量的电流模式测量电路,并分析与比较了该电路与传统的以电压作为信号变量的电压模式测量电路的不同。
补充资料：交流伏安法
分子式：
CAS号：
性质：一种叠加交流电的伏安法。即在工作电极上施加一个随时间慢扫描的直流电势Edc，并叠加峰-峰值为5mV的正弦波交流成分Eac。测量电流的交流成分的幅值和相对于Eac的相角，得到相应的交流伏安图。图中存在明确的电流峰，它与溶液中电活性物质的浓度成正比，由于无充电电流的干扰，浓度测量精度可达10-7mol/L的数量级。该法也常用于测量电极反应的动力学参数和研究反应机理。
CAS号：
性质：一种叠加交流电的伏安法。即在工作电极上施加一个随时间慢扫描的直流电势Edc，并叠加峰-峰值为5mV的正弦波交流成分Eac。测量电流的交流成分的幅值和相对于Eac的相角，得到相应的交流伏安图。图中存在明确的电流峰，它与溶液中电活性物质的浓度成正比，由于无充电电流的干扰，浓度测量精度可达10-7mol/L的数量级。该法也常用于测量电极反应的动力学参数和研究反应机理。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条