1) Expanded Polystyrene foumed plastics (EPS)
可发性聚苯乙烯泡沫塑料
2) expandable polystyrene pattern
聚苯乙烯泡沫塑料模样
3) polystyrene foam
聚苯乙烯泡沫塑料
1.
The effect of temperature difference for thermal conductiivity of moulded polystyrene foam board;
温差对模塑聚苯乙烯泡沫塑料导热系数的影响
2.
So great importance should be attached to the regeneration and recycling of polystyrene foam.
聚苯乙烯泡沫塑料因其良好的特性被广泛使用,但用后即扔对环境造成极大的污染,因此合理回收聚苯乙烯泡沫塑料,使其再生利用非常重要。
3.
The compression strength of polystyrene foam was measured according to GB/T8813-1988.
对聚苯乙烯泡沫塑料(XPS)板按GB/T8813-1988进行了压缩强度的测试。
4) waste polystyrene foam
废聚苯乙烯泡沫塑料
1.
The process of recycling the waste polystyrene foam was investigated by means of solution grafting copolymerization ,as well as the effects of the amount of initiator, reaction temperature , concentration and type of monomer, multimonomer grafting copolymerization on the grafting rate and efficiency .
用溶液接枝的方法研究了回收的废聚苯乙烯泡沫塑料的接枝工艺 ,包括引发剂的用量、反应温度、单体浓度、单体种类、多单体共接枝对废聚苯乙烯泡沫塑料接枝的影响。
5) Polystyrene foamed plastic
聚苯乙烯泡沫塑料
1.
In this paper,the method to make non-drying glue by modifying polystyrene foamed plastic waste was presented.
本文介绍了废聚苯乙烯泡沫塑料的资源化再利用—改性制备不干胶的方法;对制备工艺和产品的性能进行了优化;实验结果表明此方法制备的不干胶具有良好的不干性能,粘度大,耐水性好等优点。
6) waste foamed polystyrene
废聚苯乙烯泡沫塑料
1.
Anti-freezing adhesive produced by waste foamed polystyrene;
废聚苯乙烯泡沫塑料制取抗冻胶粘剂
2.
An antifreezing adhesive of low toxicity,low cost and superperformance can be prepared from waste foamed polystyrene (used as a principal raw material)via solvent dissolution and modification.
以废聚苯乙烯泡沫塑料为主要原料 ,经溶剂消泡、改性后可制得低毒性的、粘接强度高的、低成本的改性抗冻胶粘剂。
补充资料：可发性聚苯乙烯
发泡聚苯乙烯又称可发性聚苯乙烯，是由苯乙烯悬浮聚合，再加入发泡剂而制得。白色珠状颗粒，相对密度1．05。热导率低，吸水件小。耐冲击振动、隔热、隔音、防潮、减振。介电性能优良。溶于丙酮、醋酸乙酯、苯、甲苯、二氯乙烷、氯仿、不溶于乙醇、正己烷、环己烷、溶剂汽油等。
贮存于阴凉、通风的库房内。
贮存于阴凉、通风的库房内。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条