1) splitting-tensile strength
劈裂抗压强度
2) compressive strength and Split strength
抗压强度和劈裂强度
3) jacking strength
抗劈裂强度
1.
9 MPa and nearly horizontal,the jacking strength is about 6.
9 MPa,最小主应力状态为近水平;测点洞段围岩的抗劈裂强度一般为6。
4) Compressive strength and Splitting tensile strength
抗压强度和劈裂抗拉强度
5) split-tensile strength
劈裂抗拉强度
1.
Based on the structure of machine tools,the article studies the effect of split-tensile strength with different composition of bonds.
本文针对机床构件特点，研究了粘结料成分?PC组分配比、试件尺寸对其劈裂抗拉强度的影响，并提出一些看法。
2.
For studying the split-tensile strength of roller compacted concrete(RCC) and its size effect on meso-level,the random aggregate model was used and RCC was taken as three-phase heterogeneous composites consisting of mortar smut matrix and pulverized coal ash,aggregate,smut matrix plane and bond between matrix and aggregate on meso-level.
为了从细观结构上研究碾压混凝土的劈裂抗拉强度及其尺寸效应,采用随机骨料模型,在细观层次上将碾压混凝土看成是由硬化水泥粉煤灰砂浆体、粗骨料颗粒、二者间的黏结带和砂浆层面构成的三相非均质复合材料;利用有限元方法数值模拟研究碾压混凝土的细观损伤断裂和劈裂抗拉,对其劈裂抗拉强度及其尺寸效应进行了研究。
6) splitting tensile strength
劈裂抗拉强度
1.
9kg/m3) is investigated in terms of compressive,axial compressive,and splitting tensile strength properties.
9kg/m 3)的聚丙烯纤维混凝土的抗压强度、轴心抗压强度、劈裂抗拉强度与混凝土强度等级的关系的分析,并研究了其变化规律,得出以下结论:掺加聚丙烯纤维后,纤维混凝土与普通混凝土强度之间的关系与混凝土强度等级相关。
2.
The effects of steel fiber volumetric ratio,steel fiber slenderness ratio and steel fiber type on the splitting tensile strength,axial tensile strength and axial tensile stress-strain curve of steel fiber reinforced concrete(SFRC) are studied.
研究了钢纤维体积率、钢纤维长径比、钢纤维类型对钢纤维混凝土劈裂抗拉强度、轴心抗拉强度及轴心受拉应力-应变全曲线的影响规律。
3.
Discreteness of splitting tensile strength of marble is very great and it is influenced by the factors such as heterogeneous,splitting type and size effect and so on.
大理岩劈裂抗拉强度具有较大的离散性,并受非均质性、劈裂形式及尺寸效应等多种因素影响。
补充资料：劈裂强度
分子式：
CAS号：
性质：在规定的试验条件下，胶接试样产生分离时单位胶接宽度所需的拉伸载荷，以kN/m表示。劈裂试验是刚性材料与刚性材料胶接时胶黏剂承受集中负荷的能力。
CAS号：
性质：在规定的试验条件下，胶接试样产生分离时单位胶接宽度所需的拉伸载荷，以kN/m表示。劈裂试验是刚性材料与刚性材料胶接时胶黏剂承受集中负荷的能力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条