1) axiferous subsystem
有轴系子系统
2) rotor-shaft system
转子轴系统
1.
The main focus of this paper is put on the investigation of reducing the unbalance response of a rotor-shaft system by using a suitable polymeric or viscoelastic bearing support.
在考虑频率参数的条件下，计算了粘弹性支撑参数的变化规律，设计了计算转子轴系统不平衡响应的程序。
3) rotor-bearing system
转子-轴承系统
1.
Response analysis on linear imbalanced rotor-bearing system under nonstationary random seismic excitation;
不平衡线性转子-轴承系统的非平稳地震激励响应分析
2.
Dynamics analysis of a dual-disk over-hung rotor-bearing system with crack;
双盘悬臂裂纹转子-轴承系统的动力学分析
3.
Influences of spline coupling on stability of rotor-bearing system
花键联轴器对转子-轴承系统稳定性影响研究
4) rotor bearing system
转子-轴承系统
1.
The influence of elliptical bearing clearance on the stability of turbocompressor rotor bearing system;
椭圆轴承间隙对透平压缩机转子-轴承系统稳定性的影响
2.
? The formulas for calculating the sensitivity of unbalance response to the various parameters of the rotor bearing system of large turbogenerator sets were derived.
用有限元法导出了转子上各结点的不平衡响应对转子－轴承系统各参数灵敏度的计算公式。
3.
The reason of failure is that traditional ways of design of rotor bearing system are not so reasonable.
滚动轴承是旋转机械中最常用的易发故障零件,这是因为以前的转子-轴承系统设计方法不够合理,采用一种新的设计方法对转子-轴承系统进行优化设计,并对优化后的结果进行动力学分析。
5) bearing-rotor system
轴承-转子系统
1.
The optimization of bearing parameters was studied both based on bearing and based on bearing-rotor system using improved Genetic Algorithm respectively and the optimizing results are compared.
以轴承-弹性Jeffcott转子系统为研究对象,以三油楔固定瓦滑动轴承作为系统的支承元件,采用改进的遗传算法,分别研究了基于轴承和基于轴承-转子系统的轴承参数优化,并对两者的优化结果进行了比较。
2.
Stability and bifurcation of sliding bearing-rotor system are analyzed.
分析了轴承-转子系统的稳定性和分岔,基于系统可观测状态信息给出1种求解系统周期解及识别周期解稳定性的方法,同时将该方法与Floquet理论相结合分析系统周期解的稳定性及失稳分岔形式,将转速作为分岔参数分析系统响应的周期、拟周期、多解共存和跳跃现象。
6) Rotor-bearing system
转子轴承系统
1.
Effect of Misalignment on the Natural Characteristics of the Coupling Rotor-Bearing System With a Flexible Laminated Membrane Shaft Coupling;
不对中对膜片联轴器耦合转子轴承系统固有特性的影响
2.
The nonlinear dynamic behavior of a rotor-bearing system with rub-impact by a continuous model
非线性连续转子轴承系统碰摩故障动力学行为研究
3.
A simple model of rotor-bearing system of hydroelectric machines is built by using Riccati transfer matrix method and Newmark-βnumerical integration which had existed.
本文采用已有的Riccati 传递矩阵与Newmark-β数值积分结合的对水电机组轴系建模的方法,尝试对水电机组的转子轴承系统建立一个相对比较简单的计算模型,通过实验数据的修正后,把模型运用于工程实际。
补充资料：系子
1.指联结在器物上的细绳或带子。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条