1) end wear
端磨
1.
Via analysis of the end wearing of the roller end of the short cylindrical roller bearing, the edges of the inner and outer rings, the corresponding measures are given out.
通过对短圆柱滚子轴承滚子端面、内外圈挡边端磨现象的分析,提出了针对性的措施。
2) side face grinder
端面磨床
1.
The status,existing problems and countermeasures of the double side face grinder for large size bearings are briefly introduced.
简要介绍了大型轴承双端面磨床的现状、存在的问题和应采取的措施;重点介绍了大型轴承往复式双端面磨床的研发情况和Powermate0数控系统及其设计编程,给出了数控系统连接图。
3) face grinding
端面磨削
1.
In this paper, two types of resin bond diamond wheels with different grain size and concentration were applied in face grinding of two typical special ceramics.
本文采用不同粒度、不同浓度的树脂结合剂金刚石砂轮 ,对两种典型的特种陶瓷材料ZrO2 与Si3 N4 进行了端面磨削实验研究 ;通过在线监测磨削力和功率消耗 ,并结合加工表面的SEM微观分析 ,探讨了ZrO2 与Si3 N4 陶瓷表面的形成特征及材料的去除机理。
2.
An experimental research on face grinding of SiC particle-reinforced aluminium matrix composite 2024Al/SiCp with electroplated diamond grinding wheel was carried out.
用电镀金刚石砂轮对SiC颗粒增强铝基复合材料2024Al/SiCp进行了端面磨削实验研究。
4) end wear of bearing liner
轴瓦端磨
1.
The serious end wear of bearing liner on side dump car in certain mine is analysed and calculated,it is considered that small radius curvature of railway,high cant of rail and low running speed resulting in increase of inward inclining force of carbody,as well as lack of oil in axlebox are main causes to end wear of bearing liner.
针对某矿自翻车轴瓦端磨严重进行了分析及计算，认为铁路曲线半径小、外轨超高度大、运行速度低导致车体内倾力加大和轴箱内缺油等是造成轴瓦端磨的主要原
6) face off
研磨端面
补充资料：绝对可磨度(见矿石可磨度)
绝对可磨度(见矿石可磨度)
absolute grindability
Juedu一kemodu--一’一一一z，1」一二一」_L:1;十、、口犷绝对可磨度(absolute gr‘ndab‘l‘ty，兄刁石可磨度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条