1) smallest shearing force
剪力最小
2) minimum value of horizontal shearing force of floor
楼层水平剪力最小值
3) maximum shear
最大剪力
4) minimal span ratio
最小剪跨比
1.
The minimal span ratio in the range of the plane-section assumption in the elasticity analysis of L-shaped RC columns with different loading cases is pr.
本文选取剪跨比和弯扭比这两个影响平截面假定成立的主要参量,在截面层次上以截面应变误差分析作为平截面假定成立的定量判定依据,构件层次上以两种模型得出的柱顶侧向位移误差作为依据,对处于弹性阶段的L形柱平截面假定的适用性进行了探讨,得出了不同受力情况下平截面假定适用的最小剪跨比。
5) ultimate shear stress
最大剪应力
1.
To achieve easily and rapidly the key data of the yield shear stress and ultimate shear stress,the double-hole micro-shear,transistors and microchip machine MSP430F149 are used in the testing system.
通过双孔微剪切法、传感器和MSP430F149单片机,快速方便地获得材料的屈服剪应力、最大剪应力数据。
6) maximum shear stress
最大剪应力
1.
FEM analysis of the distributions of maximum shear stress in coating system with TiN/Si 3 N 4 double coating layers indicated that the distribution of maximum shear stress is better if the material with relatively low Young's modulus used as the surface layer.
采用有限元数值计算方法,模拟分析了TiN、Si3N4的双层涂层与GCr15基体体系中的最大剪应力分布。
2.
Based on the shear stress analysis on the different locations of the asphalt pavement structure,the paper obtains the distribution characteristics and rules of maximum shear stress under different depths of the pavement.
通过对沥青路面面层内不同位置的剪应力分析,得出了不同深度最大剪应力的分布特点及不同深度最大剪应力的分布规律。
3.
The analysis shows that maximum shear stress which come into surface-initiated under wheel load is beyond shear strength of asphalt binder.
计算结果表明,在假定的车轮荷载作用下,路面结构最大剪应力发生在路面表层,位置在轮迹边缘,其大小接近或超过常温下沥青混合料的抗剪强度,是导致半刚性路面产生TDC的主要原因。
补充资料：最小辐亮度与最小辐照度(见核爆炸火球)
最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance
zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条