1) global checking
异地校核
4) Verification
[英][,verifi'keiʃən] [美][,vɛrɪfɪ'keʃən]
校核
1.
Design of Verification,Validation and Accreditation Tool for Simulation System;
仿真系统校核、验证与验收工具的设计
2.
An Overview of Modeling and Simulation Verification and Validation Techniques;
建模与仿真的校核与验证技术综述
3.
Method for Verification of Complex Systems Simulation Models and Software;
复杂系统仿真模型和软件的校核方法
5) calibration
[英][,kælɪ'breɪʃn] [美]['kælə'breʃən]
校核
1.
Design of strength calibration application program for pump shaft parts;
水泵轴类零件强度校核的应用程序设计
2.
The calibration of parameters is a key step in the application of IWA Activated Sludge Models.
对国际水协的活性污泥法动力学模型在应用中遇到的参数校核问题进行研究 ,总结了目前常用的三种方法 :专家法、灵敏度分析法和过程工程 (ProcessEngineering)法。
3.
The process frame of selection and calibration and the interface of application are presented,selecting the type of ball-bearings used for pump are completed.
用MFC与ObjectARX相结合,在AutoCAD 2002平台上开发泵用滚动轴承的选型与校核程序。
6) checking
[英][tʃek] [美][tʃɛk]
校核
1.
Discussion about settings checking of ground fault protection from two external ground faults;
由两次区外故障谈定子接地保护定值的校核
2.
Theoretical checking for the results of finite element analysis of the heavy - duty cylinder barrels;
重型液压缸筒有限元计算结果的理论校核
3.
Development of checking software for deep well casing string in complex conditions
复杂工况下深井套管柱校核软件的开发
补充资料：校核
1.校对，核查。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条