1) fixed system error
已定系统误差
1.
It is a fixed system error.
影响沥青含量测定结果的因素主要为集料的烧失量 ,这是一个已定系统误差 ,可以用设定修正系数的方法加以消除 ,使测定结果接近约定真值 ,从而达到精确测定沥青含量的目的。
2) uncertain systematic error
未定系统误差
3) fixed error
固定(系统)误差
5) systematic errors
系统误差
1.
Two systematic errors easily neglected in the determination of suspended substances and their elimination;
悬浮物测定中两个易被忽视的系统误差及其消除方法
2.
Limit and elimination of systematic errors in the physics experiment;
物理实验中系统误差的检验和消除
3.
Adaptively robust filter based on synthetically fitting systematic errors and covariance matrices;
基于系统误差及其协方差阵拟合的抗差自适应滤波
6) systemic error
系统误差
1.
The error is always ineluctable in each measurement This text gives respectively the general formula about the systemic error and the random error,also gives the transfer formulas in special conditions ,and introduces their application technique by an example At the same time,it explains the transformation between the systemic error and the random erro
文章分别给出了系统误差和随机误差传递一般公式 ,以及特殊情况下的变形公式 ,并结合实例介绍了其应用技巧 ,同时也说明了系统误差和随机误差的转化情
2.
The systemic error of the resonance base frequency existing in dynamic Young module′s experiment is analyzed, and the cause of this type error is found that resulting from the difference between the theoretical model and the experimental restraint conditions.
从动态杨氏模量实验共振基频存在系统误差入手,认为产生这种误差的原因,是由理论上杆的自由横振动模型和实验上具有某种约束条件的小阻尼受迫振动模型之间差异造成的。
3.
According to the generation,classification and connotation of dynamic tracking systemic errors,by setting up the mathmatic model of dynamic tracking,combined with drawing,the article analyses deeply the reasons with cause the dynamic tracking systemic errors of some model of small caliber anti-aicraft gun differing from the test results of field test.
在该型小口径高炮系统的指标中,对于高炮动态射击精度、火控跟踪精度和随动系统精度都是既有随机误差要求,又有系统误差要求。
补充资料:【系统误差】(systematicerror)
【系统误差】(systematicerror)
亦称“恒定误差”。在同一条件下多次测量同一量时,误差的数值和符号保持不变,或在条件改变时,按某一确定的规律变化的误差。产生的主要原因:(1)分析方法不完善。如在重量分析中,由于沉淀的溶解和共沉淀现象等;在职滴定分析中,由于反应进行不完全和*等当点与滴定终点不符合等,均将系统地影响测定结果偏高或偏低。(2)仪器本身不够精确。如砝码重量、容量器皿刻度等。(3)试剂不纯。(4)操作者主观上带来的误差。如对滴定终点颜色的辨别不同等。为保证分析结果的准确度,对这类误差必须尽量减小以致消除。常采用标准试样和标准方法来进行校正,或由不同单位、不同人员测得的结果,进行对照和评价,从而得出校正系数以消除之。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条