说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 序阻抗
1)  sequence impedance
序阻抗
1.
The sequence impedance-based algorithm of transformer protection has the advantage of immunity to current transformer saturation and ratio-mismatch conditions.
基于序阻抗原理的变压器保护方案利用变压器发生区内外故障时,变压器两侧正负序阻抗所在象限的不同,来有效识别变压器区内外故障,文中在此方案基础上,改进了象平面区域的划分,补充了励磁涌流识别判据,并讨论了在特殊情况下所应采取的措施。
2)  positive-sequence impedance
正序阻抗
1.
They are all equal to positive-sequence impedance.
距离保护中阻抗继电器的测量阻抗值与短路类型无关,均等于正序阻抗
3)  Zero-sequence impedance
零序阻抗
1.
These leads up to the sudden decrease of the equivalent zero-sequence impedance Z_0 due to the change of electrostatic & electromagnetic couplings between phase lines and groundwir.
放电后,因地线中零序感应电流构成回路流通,形成额外的去磁作用,使得架空地线和三相导线间的电磁耦合关系骤变,这会引起相应线路等值零序阻抗Z0幅值和相位的较大变化,进而可能导致线路接地距离保护的误动。
2.
This paper analyzes the zero-sequence parameters of transmission line equipped with OPGW,and gives a calculation formula of zero-sequence impedance when different numbers of composite impedance are switched on.
为了降低逐杆接地的光纤复合架空地线(OPGW)上的能量损耗,在OPGW与地之间安装复合阻抗,对架设OPGW的输电线路零序参数进行了分析,并给出了复合阻抗导通个数不同的情况下,输电线路零序阻抗的计算公式。
3.
After analyzing the influence on zero-sequence impedance duo to the composite impedances, this paper points out that the ground distance relay s measurement impedance will be influenced as a result of the numbers of composite impedance switched on.
对输电线路的零序阻抗进行了分析,指出在OPGW(Optical Fiber Composite Overhead Ground Wires)上安装复合阻抗后输电线路的零序阻抗不再是一个定值;且随着复合阻抗导通个数的不同,输电线路的零序阻抗值以及零序电流也发生变化,从而影响到采用。
4)  zero sequence impedance
零序阻抗
1.
Measurement and research of the zero sequence impedance of the 500 kV transmission line
500kV输电线路零序阻抗的测量及研究
2.
The zero sequence impedance of the cable changes with the zero sequence current as the zero sequence current flows in the ground and the sheathing simultaneously.
电力电缆的零序阻抗随零序电流的大小而改变,如果采用恒定值的零序阻抗来进行零序电流保护的整定,容易导致保护的不正确动作。
3.
The paper presented that threoretical calculation and test methods of positive sequence and negative sequence and zero sequence impedance of power cable.
论述了电力电缆正、负和零序阻抗的理论计算以及试验方法,介绍了金属护套不同的接地互联方式下电缆相序阻抗参数特点和各序阻抗之间的关系,并对测试结果进行了分析,从而指导生产实际。
5)  positive sequence impedance
正序阻抗
1.
Using large and medium sized transformers with YN/yn/connection, different core structure and different winding arrangement as objects, the electro-magnetic phenomena of zero and positive sequence impedances during tests are investigated.
以YN ,yn ,d接线方式 ,不同铁芯结构 ,不同绕组排列形式的大、中型变压器为对象 ,通过研究零序阻抗和正序阻抗在试验中的电磁现象 ,结合试验数据进行对比分析 ,探讨零序阻抗和正序阻抗之间的关系 ,找出了二者之间的内在规律 ,供生产试验工作参考。
6)  negative-sequence impedance
负序阻抗
补充资料:星接阻抗和三角接阻抗的变换


星接阻抗和三角接阻抗的变换
transformation between starc-onnected and delta-connected impedances

x ing]一e乙日kongl介e sonJ一00}Iez日伙ongde匕一。一〕huon星接阻抗和三角接阻抗的变换(t ransfor-mation betweenstar一eonneeted and delta-eonneeted imPedanees)接成星形的三个阻抗和接成三角形的三个阻抗互相替代的等效变换。它们之间的关系可用一组变换公式表示。按这组公式,用星接阻抗替换三角接阻抗或者反过来,不会影响稳态下电路其他部分的正弦电压和电流,常用于对称三相电路的分析和计算。 图1为三个阻抗21、Z:、23接成星形(又称丫形)。图2为三个阻抗Z小22。、Zal接成三角形(又称△形)。它们之间的变换公式如下:人23土图1星接阻抗图2三角接阻抗(1)将星形连接变换成三角形连接212一Z:+22+2 122及3一22+za十警(1)、|冬|矛231一23+21+2321(2)将三角形连接变换成星形连接z、-二一典乒兴-) 艺‘2士乙“3十乙31…_2 oqZI,}Z。一下万~一二-二二-汁 乙‘2士乙23十乙3‘1_Z。IZoq}艺q一二二一~二,二二--,-二二-~J 乙12十乙23十艺32夕(2) 当三个星接阻抗相等,即21一Z:一23一z丫、三个三角接阻抗相等即212一223一231一Z△时,变换公式是 Z二一32丫,Z丫一Z△/3
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条