1) first stage extraction location after reheat
再热之后第一级抽汽位置
1.
This paper analyzes thermal economic benefits of first stage extraction location after reheat of reheat steam turbine set with outside steam cooler using partial quantitative analysis method and has obtained important results which reheat steam turbine design can rest on.
利用等效热降局部定量分析方法,分析了装设外置式蒸汽冷却器的再热机组再热之后第一级抽汽位置对热经济性的影响,得出了重要结论,可为汽轮机设计提供重要理论依据。
2) reheat stage
再热第一级
1.
The three-dimensional motion characteristics of solid particles in the first reheat stage of a supercritical steam turbine were calculated and analyzed by using a numerical method.
采用数值方法计算与分析了超临界汽轮机再热第一级的固体颗粒三维运动特性 ,根据固体颗粒撞击叶片的位置、速度与撞击角以及叶片材料的抗冲蚀性能综合分析了静叶与动叶的冲蚀机理及冲蚀特性 ,指出静叶吸力面冲蚀是从动叶反弹回来的固粒撞击所引起的。
3) bleed position
抽汽位置
4) subsequent heat extraction
机后抽汽供热
5) no-reheat extraction turbine
无再热抽汽汽轮机
6) reheat extraction steam turbine
再热抽汽式汽轮机
1.
Discussed in this paper is the differential pressure security control of the last stage blades of a reheat extraction steam turbine intermediate pressure cylinder Through an analysis of the simulation results of a mathematical model basic measures for the blade differential pressure security control have been summed u
文中对２００ＭＷ再热抽汽式汽轮机中压缸末级叶片的压差保护控制进行了探讨。
2.
The authors have worked out the static and dynamic self-regulating conditions for the control Systemof a reheat extraction steam turbine.
本文推导了再热抽汽式汽轮机调节系统的静态自整条件，结果表明再热抽汽机组的动态自整条件与凝汽抽汽机组动态自整条件是不同的。
补充资料：第一级记忆
第一级记忆
primary memory
第一级记忆(primary me印ory)见“克雷克一洛克哈特的记忆模型”。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条