1) V-block
V型块
1.
Positioning error analysis and calculation for V-blocks;
V型块定位误差的分析与计算
2.
Three Methods in Determination of Processing Locating Errors of Components in V-block;
零件以V型块定位时工序定位误差的三种确定方法
3.
We have designed an automatic device of examination and grading system of bearing inner and outer rings based on a new analytical method for V-block three-point method and labview.
基于全新的v型块三点圆度解析测量法及labview软件平台,设计了一种在线式轴承内外套圈自动检测与分级设备。
2) semicircular mutual block with V slot
半圆v型槽瓦块
3) V-block
V形块
1.
An Error Analysis of the Work Cylinder with Errors in Ellipticity and Prismatic Roundness when Located on a V-block;
具有椭圆度误差和棱圆度误差的工件外圆在V形块上定位的误差分析
2.
The model of circular form based on V-block,filter,hardware circuit and software flow are introduced.
在工序间检测的基础上,提出了轴承外圈圆度数字化测量系统方案,并在V形块定位的圆度模型推导、测量系统滤波分析、硬件电路和软件流程图方面做了介绍。
3.
A set of automatic device of detecting and grading system of bearing inner and outer rings based on V-block three-point method and labview software had been designed to improve traditional bearing detection mode.
为了改变我国轴承生产中检测的落后现状，本文在总结国内外圆度测量技术的基础上，研究设计了基于V形块三点圆度解析测量法及LabVIEW软件平台的在线式轴承内外套圈自动检测与分级设备。
4) V-shaped block method
V形块法
5) V-shape block
V形块
1.
By using language VB program to process the data of V-shape block positioning scheme computer,the method for reducing the errors in locating the work piece was put forward.
0语言编制了计算机程序,对V形块定位方案进行数据处理;分析了定位误差的大小并寻找出满足定位方案要求的工件精度等级。
2.
This paper analyzes emphatically the feature that the workpiece is located on the V-shape block by outside column surface,and discusses relation of rotor line between outer circle generatrix.
分析工件以外圆柱面在V形块上定位的特点,明晰工件回转轴线和外圆母线之间的关系。
6) V-block
V槽块
补充资料：块型相变
massivetransformation：单相系中的相变，它是通过短距离扩散而进行的，其母相和形成相具有相同的成分但晶体结构不同。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条