1) sheared air-water interface
剪切水-气界面
1.
The bursting phenomenon under a sheared air-water interface is quantitatively examined using combined-time-streak markers of hydrogen bubbles.
利用氢气泡时间线-脉线组合示踪技术定量地考察剪切水-气界面下的湍流猝发现象,分析猝发事件的信号特征,重点探讨猝发与湍能产生之间的联系。
2.
Described in this paper are careful visual and quantitative studies on ejection phenom-ena of low-speed streaks under sheared air-water interface.
对剪切水－气界面下湍流低速条带的喷射现象进行了细致的观测。
3.
Based upon samples of instantaneous velocity profiles determined by the hydrogen bubble technique, the turbulence characteristics under a sheared air-water interface are analyzed.
利用氢气泡技术测量了剪切水-气界面下二维瞬时流速的分布,根据从流动显示图像获得的流速剖面样本,考察水面附近湍流场的平均特性,重点分析猝发事件的信号特征。
2) interfacial shear
界面剪切
1.
Solutions of elastic stresses of a single fiber-reinforced composite under an appliedload paralleI to the axis of the fiber are given, The radial distribution of the axial stress inthe matrix,the distribution of the axial stress in the fiber and that of the interfacial shearstress along the fiber are presented.
本文对受一平行于纤维轴向外加载荷的单纤维复合材料给出了弹性应力的剪套解，得到基体内轴向应力沿径向的分布，以及纤维轴向应力和界面剪切应力沿纤维长度上的分布，并讨论了纤维／基体弹性模量比对最大纤维轴向应力和最大界面剪切应力的影响，而且，还将该工作与前人的工作进行了比较，最后，该文还给出了多纤维复合材料的弹性应力解。
3) oil-water interfacial shear viscosity
油水界面剪切粘度
4) interfacial shear stress
界面剪切力
1.
The analysis results shown that the effect of interfacial shear stress cannot be ne- glected for a small diameter thermosyphon,especially for a small inclination degree to horizon.
建立了太阳能热水装置用的热虹吸管在倾斜状态下冷凝段流动传热模型,模型考虑了倾斜角度和界面剪切力对冷凝液膜的影响。
5) interfacial shear
界面剪切力
1.
Under a gas flow at the gas-liquid interface,the stability is obviously influenced by the interfacial shear at the boundary condition.
基于边界层理论,采用积分法建立了剪切力作用下降液膜表面波演化方程,分析了界面剪切力对水动力稳定性的影响。
6) interfacial shear strength
界面剪切强度
1.
The results showed that the interfacial shear strength between PBO fiber and epoxy resin were greatly improved after the modification,the.
通过单丝拔出实验研究了偶联剂对不同表面形态纤维的表面处理情况,结果表明:用偶联剂表面处理后,纤维与树脂间的界面剪切强度得到提高,偶联剂对未经烘干纤维表面处理比对烘干纤维处理的效果要好,与原丝相比,提高率可达69。
2.
A method of preparing single fiber pull-out specimens was designed,and the interfacial shear strength(IFSS) of Bf/epoxy resin composites was measured by single fiber pull-out rest.
设计了一种单根硼纤维拔出试样制备方法,并测试了不同树脂基体的硼纤维/环氧复合材料的界面剪切强度;研究了单根硼纤维拔出界面破坏过程。
3.
The single fiber fragmentation test has been used to determine the interfacial shear strength of composite materials.
单纤维段裂试验作为复合材料界面剪切强度的一种测试方法被沿用至今。
补充资料：液气界面
液气界面
液体与气体的接触分界处。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条