1) output force characteristics
输出力特性
1.
It can be used to forecast the output force characteristics of this hydro-pneumatic cylinder.
以3303B型矿用自卸车的油气悬挂缸为研究对象,建立油气悬挂缸的数学模型,并对其进行了试验研究,通过将仿真结果与实验结果对比可以看出,所建立的模型准确可靠,可以用于该油气悬挂缸输出力特性的预测研究,故利用该模型对油气悬挂缸在不同温度、阻尼孔直径和初始充气压力时的输出力特性进行了研究,从结果可以看出,这三个参数的变化对油缸的输出力特性有很大的影响。
2.
On the basis of previous work,the RBF forecasting platform for Hydragas suspension output force characteristics has been established.
利用所得的试验数据,应用RBF网络建立该型油气悬挂的非参数化模型,然后通过该模型对油气悬挂的输出力特性进行预测,并与BP网络得到的数据比较。
2) output property
输出特性
1.
Analysis of simulation model used for studying the output property of controllable saturable reactor;
可控饱和电抗器输出特性建模与仿真研究
2.
An instrumentation based on single-chip processor is presented for studying the output property of saturable reactor.
介绍一种研究可控饱和电抗器输出特性的单片机测试仪,用于检测并处理可控饱和电抗器中的感应线圈电压波形的平均值、有效值。
3) output characteristic
输出特性
1.
Investigation on output characteristics of traveling wave thermoacoustic engine with multiple loads;
行波热声发动机的多负载声功输出特性
2.
Output characteristics of a Ka-band, second harmonic three-cavity gyroklystron amplifier;
Ka波段二次谐波回旋速调管放大器的输出特性
3.
The power supply has steady current-steady voltage output characteristics, and it is fit for battery charger.
该电源为恒流—恒压输出特性,适用于作蓄电池充电器。
4) output characteristics
输出特性
1.
Effect of dye-sensitized solar cell nanostructure on cell output characteristics;
染料敏化太阳电池纳米结构对输出特性的影响
2.
Design of Simple Transistor Output Characteristics Curve Tracer;
简易晶体管输出特性图示仪的设计
3.
Analysis of output characteristics of a YAG laser;
YAG激光器输出特性的分析
5) output character
输出特性
1.
Output Character Analysis of Optical Current Sensor;
光学电流传感器的输出特性分析
2.
Output character of sequence band lines of TEA CO_2 laser;
TEA CO_2激光器序列带的输出特性
3.
The influence of dithering amplitude and frequency on the output character was analyzed.
建立了激光陀螺机械抖动装置的仿真模型,研究了机抖温变特性对激光陀螺输出特性的影响。
6) output performance
输出特性
1.
Output performance of solid state heat capacity laser with active-mirror and dichromatic coatings;
双色膜V形有源镜结构的固体热容激光器输出特性
2.
The output performance of the tetralateral two dimensional(2D) position sensitive detector(PSD) while only two of its four output electrodes worked alternately was experimentally investigated,then a finiteelement method(FEM) was used to simulate and calculate,and the computational results were agreement with the experiments.
对四边形结构二维位置敏感探测器(PSD)的单方向输出特性进行了实验研究,并用有限元法(FEM)进行了模拟和计算,计算结果与实验结果完全吻合。
补充资料：计算机输入/输出控制系统(见计算机输入/输出系统)
计算机输入/输出控制系统(见计算机输入/输出系统)
computer input/output control system
iisuanii shuru/shuehu kongzhi xitong计算机输入/输出控制系统(com-puter inPut/ou中ut eontrol system)见计算机输入/输出系统。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条