1) heat exchange coefficient
对流热交换系数
2) convection
对流
1.
Various issues in turbulent thermal convection;
湍流热对流中的若干问题
2.
Experimental study on heat transfer characteristics with forced convection in narrow annulus;
窄环隙内强迫对流换热特性的实验研究
3.
Comparison and analysis research on numerical method for pure convection transport;
对流方程数值解法比较及分析研究
3) advection
对流
1.
New method for computation of two-dimension advection transport;
平面二维对流输移问题新解
2.
The model consists of a set of algorithms, describing the processes of advection, turbulent diffusion, surface spreading, vertical dispersion, emulsification and evaporation.
该模型包含了一系列的数学公式来描述对流、湍扩散、表面扩展、铅直扩散、乳化和蒸发过程。
4) thermosolutal convection
热质对流
1.
The thermosolutal convection during directional solidification of multi-element compound crystals alloy in vertical Bridgman configuration arises from the interaction between temperature and solute gradients in the bulk melt.
在垂直Bridgman晶体生长装置中,熔体的热质对流是由于温度梯度和浓度梯度间的相互作用引起的,而温度梯度和浓度梯度由晶体热物性和生长炉结构所决定。
2.
The thermosolutal convection during the growth of binary alloys in the ideal vertical Bridgman configuration,the prototype furnace,is numerically studied with pseudo-steady-state model.
以GeSi半导体合金为例,采用准稳态模型数值研究了理想垂直Bridgman装置-原型炉中二元合金单晶生长过程的热质对流现象,分析了热瑞利数、生长炉绝热区长度对热质对流、熔体径向溶质分凝的影响规律。
3.
The thermosolutal convection during the directional solidification of binary alloy GeSi in vertical Bridgman configuration is numerically studied by using pseudo-steady-state model.
以GeSi半导体合金为例,采用准稳态模型数值研究了垂直Bridgman三段热管炉中二元合金单晶生长过程中的热质对流现象。
5) troposphere
对流层
1.
Photochemical progresses and influencing factors in the troposphere related with acid rain;
与酸雨相关的对流层光化学过程及其影响因素
2.
Attenuation Prediction for 1.06 μm laser propagation in the troposphere;
1.06μm激光在对流层传输中的衰减预测
3.
Computer Simulation of DGPS Troposphere Pseudo-Range Remaining Error;
差分GPS的对流层伪距残差的计算机模拟
6) natural convection
自然对流
1.
Characteristics of natural convection flow and heat transfer in cavity with multi-openings;
多开口方腔内自然对流的流动与传热特性
2.
Numerical simulation of natural convection in the transient gas-liquid unsteady absorption process;
吸收过程自然对流非稳态数值模拟
3.
Comparison of natural convection with fire plumes in typical shafts;
典型竖井内火羽流与自然对流的比较
参考词条
补充资料：板翅式热交换器（platewingheatexchanger）
板翅式热交换器（platewingheatexchanger）
铝制板翅式热交换器是在数层平金属板之间紧密地放置波纹状的金属导热翅片，并在每一层的四周加上封条，于温度近600℃的盐溶液炉中整体铅焊而成。翅片的主要作用是强化传热，也有增强两金属板强度的作用，在这种热交换器中相邻两通道之间的热交换，一部分通过平板传递热量，但绝大部分热量是通过波纹翅中传递的，因为平板之间均有波纹翅片，因而大大增加了传热面积，所以它的单位体积内的传热面积比一般管式热交换器大10倍以上，达到4000～5000m2/m3。通过各通道之间的不同组合，可得到逆流、错流等形式的热交换器。它具有单位体积传热面积大、传热效率高、流体阻力小、热容量小、结构紧凑及同时允许几种介质进行热交换等优点。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。