1) sliding mode theory
滑模理论
1.
The importance of the sliding mode theory in the variable structure system is expressed.
阐述滑模理论在变结构系统中的重要作用。
3) lubrication theory
润滑理论
1.
Through the lubrication theory modeling, the paper has studied the influences of such technological parameters as gas volume rate, gas slot width and casting speed on the gas film pressure distribution in the gas film soft-contace continuous casting technology.
通过建立铝合金气膜软接触连铸工艺润滑理论模型,分析气体流量、拉坯速度、气缝宽度等参数影响结晶器内气膜压力分布的规律。
2.
The flow problems in profile extrusion dies were solved with lubrication theory in this paper; The velocity distribution vertical to the flow direction was calculated with cross section method; The pressure drop was also obtained from a means of hypothesis district, if the flow rate had been known.
采用润滑理论解决异型材挤出口模中的流动问题 ;采用横截面法求解垂直于流动方向的横截面上的速度分布 ;在流动速率已知的情况下 ,采用假定区域法求得压力降。
3.
Based on the Reynolds lubrication theory, squeeze flow between two parallel plates of a Bingham fluid with partial wall slip was considered.
以Reynolds润滑理论为基础 ,研究了存在滑移时两刚性圆盘间宾汉流体的挤压流动。
4) the theory of slippery slope
滑坡理论
5) creep theory
蠕滑理论
1.
A program for spatial analysis of train-bridge coupling vibration is developed on the basis of wheel-rail contact creep theory.
运用基于蠕滑理论的车桥耦合振动空间分析程序,分析了混编货车通过铁路上标准32 m跨径预应力混凝土简支梁时的车桥振动特征。
6) slippery theory
滑移理论
1.
According to this principle, the backflow patterns in the impeller with differently offset short blades are analyzed for a situation in engineering practices by using the slippery theory.
依此原则,文中以滑移理论为工具,实例分析计算了短叶片在不同偏置位置时叶轮内部的回流情况,进而得到了离心泵叶轮短叶片应偏置的最佳位置。
2.
According to the data simulated and the pump performance experimentally measured,the slippery theory can be used to accurately predict the pump head at design condition and the effect of blade angle on the pump performance.
通过分析及试验研究表明,采用滑移理论可以准确分析设计工况点叶片安放角变化规律对泵性能的影响,双圆弧和线性变化规律的差别对泵的扬程影响不大,单圆弧叶片叶轮的扬程略低。
补充资料：采用滑模工艺建造钢筋混凝土烟囱
采用滑模工艺建造钢筋混凝土烟囱
采用滑模工艺建造钢筋混凝土烟自
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条