1) stress control tube
应力控制管
1.
A comparison of the electric field distribuˉtion in cable terminations with several different stress control tubes is investigated under impulse voltage.
利用暂态有限元方法分析了含不同应力控制管时的电缆终端冲击电压下的电场分布。
2.
A comparison of the electric field distribution in a cable termination with several difˉferent stress control tubes is presented.
利用时域有限元方法分析了含不同应力控制管时的电缆终端电场分布。
2) stress grading bushing
应力控制型套管
1.
Simulative calculation and test validation of the electric field round stress grading bushing optimized by nonlinear dielectric;
非线性电介质改善应力控制型套管电场的模拟计算与试验分析
3) stress control
应力控制
1.
Study on stress control standards of high arch dam with self-adaptive finite element method;
利用自适应有限元研究高拱坝的应力控制标准
2.
According to the model,the phenomena of cyclic softening manifests that mean strain is increased with the increasing of the number of cycles in the low cycle fatigue under the stress control.
由该模型可知:应力控制的低周疲劳中,循环软化现象表现为平均应变随循环数增加而增加,材料的损伤包括循环塑性损伤和由随循环数增加的平均应变引起的蠕变损伤,同时得到了三轴应力场中的疲劳失效准则和损伤演化方程。
3.
By a series of pulsating cyclic tests of 16MnR steel under stress control at elevated temperature,transformation laws of the damage variable were measured at different maximum stresses at.
通过16MnR钢在中温应力控制条件下的脉动循环试验,测出在相同温度、不同最大应力以及相同最大应力、不同温度下的损伤变量变化规律。
4) control stress
控制应力
1.
In view of the cracking problem in box girder,insufficient design method of concrete box girder in our country is analyzed,and method of control stress value selected about concrete box girder is discussed.
针对箱梁混凝土开裂问题,分析了我国混凝土箱梁设计方法的不足,探讨了箱梁混凝土控制应力的取值方法。
5) constant stress controlled
恒应力控制
6) stress control method
应力控制法
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条