1) top cover of electrical parts holder
电器盒面盖
1.
The injection mold of top cover of electrical parts holder feeds material from the center of products back by hot mouth structure, which improves the fluent character of PC material, and saves gate concretionary material after forming, as well as shortens the forming cycle of plastic parts.
电器盒面盖注射模采用热嘴结构从产品背面的中心进料,既改善了PC料的流动性,又节约了成型后的浇道凝料,还缩短了塑件的成型周期。
2) upper cover of power supply box
电源盒上盖
1.
Application of CAE technology in optimization design of injection mould for the upper cover of power supply box
CAE在电源盒上盖注射模设计中的优化应用
3) relay box
继电器盒
1.
The relay box has long been checked by manual work.
飞机继电器盒长期以来一直采用人工方法进行检测,其检测精度和效率已不能满足现代飞机的使用要求。
2.
Two screws and the busbar connected with them in a relay box ruptured during vibration testing.
在振动试验中继电器盒上的两个螺钉及与之相连的汇流条发生断裂。
4) electric appliances bottom box
电器底盒
1.
This text introduces of usual construction and usage condition of metal electric appliances bottom box,and detailedly analyzed its type craft.
本文分析了金属电器底盒的基本结构及使用状况,提出了其成型工艺方法。
5) condenser block
电容器盒
6) pump governor case cover
泵调节器盒盖
补充资料：马鞍山出土的三国戗金盒盖
马鞍山出土的三国戗金盒盖 一九八四年六月安徽马鞍山三国东吴朱然墓出土。盒盖边长22．6厘米，高11．5厘米，其上刻画了九幅锥画，三个人物，六十五个瑞兽。人物，或佩剑、或持节、或拥旗，个个栩栩如生；瑞兽或邀游、或腾飞、或疾走，个个刻画入微；整个漆盒盖饰以戗金，面积在一千五百余平方厘米，规模可观。其金在地下埋藏历1700多年，仍灿然华美，实为我国古代漆器中的一件珍品。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条