1) elastic-brittle-plastic constitutive models
弹脆塑性本构模型
2) elastic-brittle-plastic constitutive model
弹-脆-塑性本构模型
3) elastoplastic constitutive model
弹塑性本构模型
1.
Numerical format of elastoplastic constitutive model based on the unified strength theory in FLAC~(3D);
统一弹塑性本构模型在FLAC~(3D)中的计算格式
2.
A new method to define slippage line under local loading condition is presented based on Hill’s principle of strain bifurcation and the elastoplastic constitutive model of soil.
借助 Hill 的材料应变局部化原理和土的弹塑性本构模型,应用声学张量示踪边坡失稳滑移线发生和发展,提出了局部加载条件下的确定边坡失稳滑移线的方法。
3.
Based on the above physical fundamentals of sands subjected to cyclic rotation of principal stress axes,a new cyclic elastoplastic constitutive model for saturated sands aiming at describing the deformation behavior of sands due to cyclic rotation of principal stress axes is developed.
基于对上述应力主轴循环旋转条件下砂土的基本变形规律的认识,采用将主应力幅值变化以及应力主轴旋转产生的塑性变形单独加以考虑的办法,建立一个可合理考虑应力主轴循环旋转效应的砂土弹塑性本构模型,并对该模型在包含应力主轴旋转的多种复杂循环应力路径下的有效性进行验证。
4) elasto-plastic constitutive model
弹塑性本构模型
1.
Based on this yield criterion and elasto-plastic theory,an elasto-plastic constitutive model for coarse materials is established.
根据大坝应力路径,对粗粒料进行等应力比和等应力比增量等于常数的三轴剪切试验,得出了相应的应力–应变关系式和规律;根据粗粒料的试验强度曲线特征,提出用幂次型函数表述粗粒料的抗剪强度,并以此为屈服准则,结合弹塑性理论建立了粗粒料的弹塑性本构模型,该模型可以用一个统一的表达式表述,该模型概念清晰、模型参数较少;同时推导出粗粒料的弹塑性矩阵;通过试验验证模型计算得到的粗粒料应力–应变关系曲线和实测结果吻合较好。
2.
Based on the results of test under complex stress, the relationship of stress-strain under the principal stress with different directions is studied through experiments, and according to this, combined with the concept of state, an elasto-plastic constitutive model based on relationship of stress-dilatancy and simulated hyperbolic relationship of stress-strain is put forward.
基于复杂应力条件下的试验结果,就针对不同主应力方向对应力–应变关系的影响进行了试验研究,并在此基础上结合状态概念提出了基于应力–剪胀关系和应力–应变拟双曲线关系的弹塑性本构模型。
5) elastic-plastic constitutive model
弹塑性本构模型
1.
Ubiquitous volume-retraction during load-decreasing process is an important factor leading to liquefaction and failure of saturated sand, which could not be reasonably explained by existing elastic-plastic constitutive models of soil.
普遍存在的减载体缩现象是导致砂土液化和破坏的重要因素,但尚难以用现有土的弹塑性本构模型合理解释。
6) elasto plastic constitutive model
弹塑性本构模型
1.
The twin shear strength theory and unified strength theory proposed by Yu Mao-hong in 1983 and 1990 respectively are extended to be used as a general unified elasto plastic constitutive model in this paper.
本文将第一作者于１９８３年提出的双剪强度理论和１９９０年提出的统一强度理论推广为涵义更广的统一强度理论弹塑性本构模型，并将它们在计算机程序中实现，应用于结构弹塑性分析。
补充资料：弹—塑性变分原理
弹—塑性变分原理
elastic-plastic variational principle
tan一suxing bionfen yuanll弹一塑性变分原理(elastie一plastic variation-al Principle)适于弹一塑性材料的能量泛函的极值理论。包括最小势能原理和最小余能原理。塑性加工力学中常用最小势能原理。变形力学问题的能量解法和有限元解法都基于最小势能原理。最小势能原理有全量理论最小势能原理和增量理论最小势能原理。 全量理论最小势能原理在极值路径(应变比能取极值的路径)下运动许可的位移场u‘中，真实的位移和应变使所对应的总势能取最小，即总势能泛涵巾取最小值，其表达式为”一0，’一万〔A(一，一关一〕dV一好多!一‘“ (l)式中“:为位移;户:为外力已知面上的单位表面力;关为体力;A(气)为应变比能。 A(勒)随材料的模型而异。对应变硬化材料(图a)， E严_‘_‘_ A(乓r)一二丁二一气助+{刃(r)dr(2) 6(1一2刃~一“‘J一、-一、- 0式中E，，分别为弹性模量和泊松比;艺一硫瓜，r一掩不万，，，f，一，一音。魔。，，一，一，一音。*。!，;。f，为克罗内克(L.Kroneeker)记号，i=夕时a，一l，i笋少时民，一。，把式(2)代入式(1)便得到卡恰诺夫(几·M·Ka、aHoe)原理x的表达式。i厂:八 I’—几 I’一 ab 乞一乏(r)关系图 a一应变硬化材料;占~理想塑性材料 对于理想塑性材料(图b)， 艺~ZGr(r
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条