1) oil and water temperature
油水温度
1.
Reason analysis and emergency treatments of high oil and water temperature in DF_4 locomotive diesel and modification of hydrostatic system;
DF_4型机车柴油机油水温度高的判断、处理及对静液压系统的改造
2) oil-gas-water mixture transportation temperature
油气水集输温度
3) oil return temperature
回油温度
1.
Defining the limit value of oil temperature and automatically controlling the oil return temperature are effective measures for reducing gas and energy consumption.
精确界定油井温度界限值,对回油温度进行自动控制是降低气耗、能耗的有效措施。
5) crude oil temperature
原油温度
1.
Effect of pipe wall and crude oil temperature on wax deposition in pipeline transportation;
输油管道系统管壁温度与原油温度对蜡沉积的影响
2.
By analyzing the data which are obtained by oil pipeline crude oil temperature circuit monitor system,we summarize a series of oil temperature drop laws.
分析原油储运油库输油管道原油温度巡回监测系统的温度测试数据,得到油库输油管道原油降温规律:不同输油管道的温降速率与平均温差的关系不同,同一输油管道不同位置(轴向)处的温降速率与平均温差的关系也不同;随着平均温差的增大,位于中心右侧的输油管道的温降速率增大,位于中心左侧的输油管道的温降速率则减小;温降速率与平均温差并不呈线性关系。
6) reservoir temperature
油藏温度
1.
The results show: APS has special rheological behavior different to general HPAM solution, the rheological rules differ above CAC (Critical Association Concentration, CAC) and under CAC, and are different in different actual reservoir temperature and salinity.
在国内三个典型的注聚油藏条件下,主要研究了缔合聚合物溶液的宏观流变性,并与一般超高分子量的MO4000溶液的流变性进行了比较,结果表明,缔合聚合物溶液具有不同与一般HPAM溶液的特殊的流变性,临界缔合浓度CAC(Critical Association Concentration,CAC)以上、下缔合聚合物具有不同的流变性,同时实际的油藏温度和盐水矿化度不同,缔合聚合物溶液表现出了不同的流变规律,要研究缔合聚合物溶液的流变性必须在实际的油藏条件下进行;同时在CAC以上缔合聚合物溶液的粘度远于超高分子量MO4000溶液的粘度。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条