2) strip rolling
板材轧制
1.
Firstly,the rigid plastic finite element code of strip rolling was programmed by FORTRAN language.
针对有限元模拟,如发展板材轧制快速有限元计算对计算精度和计算速度的不断提高,研究了快速发展的计算机软硬件条件对计算速度和计算精度的影响。
2.
This paper aims at the improvement of the calculation speed of rigid-plastic FEM of strip rolling.
本文以提高板材轧制刚塑性有限元的计算速度为目标,研究采用 Newton 法求解刚塑性有限元的能耗率泛函时初始速度场的设定对计算速度的影响。
3) rolling sheet
轧制板材
1.
Heat treatment of Mg-Zn-Y-Zr alloy rolling sheet
Mg-Zn-Y-Zr合金轧制板材的热处理
2.
The results show that the grains in the single direction rolling sheet is changed from strip to equal axis shape because of the recrystallization and twin crystals disappearance during annealing heat treatment,and there are some fine grains although part grains are grown.
研究不同退火工艺下AZ31镁合金轧制板材显微组织以及冲压性能。
4) plate rolling/HCW mill
板材轧制/HCW轧机
6) plate mills
板材轧机
1.
The gap crown between two work rolls of plate mills and the strip shape can be adjusted by axial shifting of the work rolls, both of them have a special contour.
板材轧机上一对带特殊辊型的工作辊轴向相对移动时，可改变辊缝凸度，调节板形。
补充资料：板带轧制速度规程(见板带轧制规程设计)
板带轧制速度规程(见板带轧制规程设计)
speed schedule for plate and strip rolling
bandai zhazhi sudu guieheng板带轧制速度规程(speed seheduxe fo:plateand strip rolling)见板带札制规程设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条