1) initial eccentricity
初偏心
1.
This paper has discussion about the effect on the stability of pile caused by an initial eccentricity and then gives some suggestion that should be adopted in practical engineering fields for reducing the unfavourable effect.
探讨了桩有初偏心时对基桩稳定性的影响问题 ,并提出了在实际工程中减少其影响的措施。
2.
Afurther and comprehensive discussion is alsomade on influence of initial eccentricity of vertical load on the inside surface of silo wall.
对于影响钢板稳定因素中竖直荷载作用于筒仓内壁这种荷载初偏心的影响，进行了深入研究和探讨。
3.
Based on the differential equation of load-bearing of small deflection bar,the critical load of bending unstability of the elastic body was confirmed,and the relation between the critical load and the initial eccentricity was obtained.
针对有初偏心的水下高速运动弹性体的抗弯稳定性问题,建立了一个简化的力学模型。
2) original eccentricity distance
初始偏心距
3) eccentricity of rest
静止偏心距;初偏心距
4) muzzle velocity deviation
初速偏差
1.
Precision fire of AA gun must accurately confirm and correct muzzle velocity deviation and adjustment.
高炮要准确射击必须准确确定和修正初速偏差量。
5) initial errors
初始偏差
1.
Under the conditions of small initial errors,the satisfied resul.
测试结果表明该近似算法得到的零控脱靶量与真实值比较接近,在较小初始偏差条件下,简化的近似计算公式能给出满意的结果,所得零控脱靶量可用于空间动能拦截制导系统的初步设计与分析。
6) secluded junior school
偏远初中
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条