1) angle steel tube pole
承力钢管杆
1.
this thesis analyzes deflection change of 110kV double circuit angle steel tube pole during design and install deflection,obtains that install deflection is bigger than design deflection,puts forward limit of design and install deflection.
本文以110kV双回承力钢管杆为例,分析了钢管杆杆顶挠度在设计、安装的过程中的变化,得出了安装后的杆顶挠度要大于杆顶设计挠度的结论,从而提出了110kV承力钢管杆的设计、安装挠度的限值。
2) load-bearing bar
承力杆件
1.
Analysis has been made on load-bearing bar of thermosetting resin based composite insulator,it is indicated that this kind of material has disadvantages such as low elastic modulus,poor heat resistance,easy aging inclining,directional mechanical properties as well as scattered material properties;especially there is hydrolysis phenomenon.
对热固性环氧树脂基复合材料的绝缘子承力杆件进行了分析,指出此种材质存在弹性模量低、耐热性差、易老化、力学性能的各相异性以及材料性能多呈分散性等缺点;尤其是存在水解现象。
3) supporting steel pipe
支承钢管
4) pressurized tubes
承压钢管
6) steel-tube support
钢管杆塔
1.
A design scheme of HV steel-tube supports based on principle of robustness is presented in this paper.
提出了基于稳健性设计的高压钢管杆塔设计思路,以东莞设计院3款不同类型钢管杆型设计方案进行了实例分析。
补充资料：宝鸡石油钢管厂大口径薄壁钢管的φ508排辊成形机组
宝鸡石油钢管厂大口径薄壁钢管的φ508排辊成形机组
宝鸡石油钢管厂大口径薄壁钢管的中508排辊成形机组
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条