1) Hot spot
高温点
2) distribution of high temperature points
高温点分布
3) pyrogen igniter
高温点火器
4) high-temperature spot in tunnel kiln
隧道窑高温点
5) high temperature
高温
1.
Numerical simulation of hydrodynamic behavior in a high temperature gas-solid fluidized bed with coarse granules;
高温大颗粒气固流化床流化行为数值模拟
2.
Investigation on mechanical behavior of HPC mixed with fiber after high temperature;
外掺钢纤维对高性能混凝土高温后性能的影响
3.
The desulfurization behavior of mineral matter in ash during coal combustion at high temperature;
高温环境下灰中矿物质对长广煤燃烧固硫行为的影响
6) elevated temperature
高温
1.
Synergistic improving fretting fatigue resistance of Ti alloy at elevated temperature by duplex surface modification;
复合表面改性协同增强Ti合金高温微动疲劳抗力
2.
Experimental study on properties of concrete exposed to elevated temperatures at various heated time;
不同时间高温后混凝土性能的试验研究
3.
Fretting fatigue behaviors of Ti811 alloy at elevated temperature;
Ti811合金的高温微动疲劳行为
参考词条
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。