1) residual loss
剩余损耗
1.
Even under low frequency,residual loss exists still.
结果表明:掺杂适量CaO、S iO2的锰锌铁氧体不仅其涡流损耗比重大大下降,而且磁滞损耗也大为降低;在一定温度范围内,烧结温度对样品的功耗影响不大;在低频率段,仍然存在剩余损耗。
2) residual loss
其它损失，剩余损耗
3) excess loss
过剩损耗
1.
According to the commonly used method, decomposing the total loss into the three components, we have carefully examined the non linear behavior of the excess loss per cycle.
将总损耗分离为三部分后 ,仔细地考查了每周过剩损耗的非线性行为。
2.
Decomposing the total loss into the sum of hysterisis loss, classical eddy current loss and excess loss, we have carefully examined the nonlinear behaviour of the low-frequency loss per cycle.
将总铁损分离为磁滞损耗、经典涡流损耗和过剩损耗之和 ,我们仔细地考查了每周低频损耗的非线性行为。
4) a ratio of surplus loss to profit
剩余损益比
5) rest loss-benefit degree
剩余损益度
1.
They are loss -benefit ratio of geologic environments,ratio of input to loss reduced for the program of reducing geologic hazard,rest loss-benefit degree, and the efficiency of exploring geologic environments.
本文给出地质环境开发利用工程的地质环境损益及地质灾害降损方案经济评价的四项经济指标和计算模型—地质环境损益比、减灾方案投入降损比、剩余损益度及地质环境开发利用率。
6) residual wear life
剩余磨损寿命
1.
Based on the demand of mechanical machining shops, the forecasting modes of cutting tool residual wear life in MES of CIMS is investigated, the coefficient express in the calculating formula for cutting tool residual wear life is derived, and a implemental method of forecasting cutting tool residual wear life in practical machining is put forward.
以机械加工车间为背景,探讨了在CIMS环境下制造执行系统中刀具剩余磨损寿命的预测模式,推导了刀具磨损寿命计算公式中的系数表达形式,并提出了刀具磨损寿命预测在实际加工中的实现方式。
补充资料：介质损耗角正切试验(见电容率与损耗因数试验)
介质损耗角正切试验(见电容率与损耗因数试验)
dielectric loss tangent test
)!eZh.sunhooJ一002匕engq一e sh一yon介质损耗角正切试验(dieleetri。1055 tangenttest)见电容率与损耗因数试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条