1) short-term load-current
短期负载电流
1.
Based on them,and referring to the determination of parameters in current capacity as well,the methods to calculate the short-term load-current for cables buried in earth with backfill soil and l.
综合了空气中、直接埋地两种敷设下电力电缆短期允许负载电流的计算方法,研究了其中土壤划分区域个数的选择、短时负载前电缆非满载运行下线芯温度的确定等问题并参考载流量计算中相关参数的确定方式,给出了电缆在直埋更换回填土以及水泥槽中管道敷设情况下的短期负载电流计算公式,并以简单计算验证其正确性。
2) cyclic current rating of cables
电缆周期负载载流量
3) load current
负载电流
1.
Single-phase parallel hybrid active power filter adopting novel control approach of load current detection;
采用负载电流检测控制方式的单相并联混合型有源电力滤波器
2.
The principium of hot rolling bar shear controlled by T400,and the effect of speed set-point characteristic to load current are analyzed.
针对热轧棒材倍尺飞剪高速剪切时存在速度滞后并超调,影响产品质量,制约生产线运行速度的问题,对采用T400工艺板控制的热轧棒材倍尺飞剪,从原理上解析速度给定曲线对负载电流的影响,以参数化编程的方式实现控制方案优化。
3.
The analysis and Matlab simulation results show that the proposed controller greatly improves the dy- namic behavior of buck converter caused by fast variation of input voltage and/or load current,features clear physical meaning and easy design.
针对Buck变换器快速动态响应的要求,本文提出了一种具有快速动态响应速度的非线性控制方法——根据负载电流调节的电感电流滞环控制。
4) loading current
负载电流
1.
Based on the theoretical analysis of each factor inducing vibration of core and winding, the experiments validated that the fundamental frequency magnitudes of core and winding vibrations are linear to square of no-load voltage and loading current respectively.
在理论研究影响铁心及绕组振动各因素的基础上,实验验证了在空载状态下油箱表面测得的,铁心振动信号的基频幅值与施加电压的平方以及绕组振动信号的基频幅值与流过绕组的负载电流平方都呈较好的线性关系。
6) large load current
大负载电流
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条