1) stress peak
应力最值
1.
Mean Square of stress peaks is brought out in this paper for purpose of assessing the optimized product.
本文指出了优化设计在目前产品设计领域的必要性;用数理统计的方法对多工况下应力最值方差作出评价,为多工况受力零件的设计评价及结果优化提供了数值依据。
2) the maximum of Mises stress
Mises应力最大值
1.
It is verified that adopting the maximum of Mises stress on all of the nodes of the element as the stress constraint is reasonable.
对结构优化中常用的二维连续体单元进行讨论，论证了取诸节点处Mises应力最大值作为应力约束的合理性。
3) magnitude of maximum shearing stress
最大剪应力值
4) radial tension stress
径向最大拉应力值
5) maximal force
最大力值
6) maximum stress
最大应力
1.
Combined with the project examples,it introduces the construction methods of basic mass concrete,gets the calculation to the temperature of mass concrete,foundation restraint coefficient,shrink,maximum stress and the anti-crack coefficient,and puts forward the steps of assuring the not crack of concrete,this will assure the project quality of mass concrete.
结合工程实例,介绍了基础大体积混凝土的施工方法,进行了大体积混凝土温度、地基约束系数、干缩及最大应力及抗裂安全系数的计算,并提出了确保混凝土不开裂的措施,从而保证大体积混凝土的工程质量。
2.
It has found out these members dangerous position with the maximum stress and calculated the stress value, made the goal and the range of daily check more definite and concentric, provided the theory basis for establishing reasonable particle check system.
用大型有限元程序ANSYS分析了10t门座起重机主要构件的力学性能,找出了这些构件具有最大应力的危险部位并求出了它们的数值。
3.
The stress accumulating region and the maximum stress is calculated through cosmosm statics analysis program.
以１５０轨钢机上无螺栓十字轴万向联轴器叉头为例，建立了叉头的三维有限元分析模型，并运用Ｃｏｓｍｏｓｍ程 序进行静力学分析，找出了叉头的应力集中区和最大应力值，分析了叉头发生破坏的原因，提出了叉头 结构设计时可采取的措施。
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条