1) angle of the cut
割口深度
2) Cutting depth
切割深度
1.
A theoretical model based on energy balance was presented that predicted the cutting depth with respect to material properties and cutting speed.
介绍了CO2激光汽化切割非金属板材的机理,建立了理论模型,并根据材料的性质和切割速度预测切割深度。
2.
CO2 lasers is conducted to cutting die- board with the aim of discussing the relationship between cutting depth and parameters such as laser power, cutting speed and focal position.
采用CO2激光切割模切板,研究激光功率、切割速度、焦点位置等参数和切割深度之间的相互关系,研究如何确定最大切割速度和优化切割速度。
3.
Theoretical analysis and experimental results all indicate that cutting depth is increasing with the decreasing of cutting speed and increasing of laser power.
理论分析和试验结果表明切割深度随着切割速度的减小而增加,随着激光功率的增加而增大。
3) depth of cutting veins/ stria depth
割纹深度
4) depth of cut
切割深度
1.
Parameters affecting the depth of cut, such as the driving pressure, stand off distance, traverse velocity of the jet and abrasive density were studied The cutting property in unsubmerged condition is compared with that under submerged condition It is found that the stand off distance of the jet has much influence on the depth of cut in submerged condition .
本文介绍了前混合磨料射流淹没和非淹没状态下切割实验系统 ,研究了两种状态下前混合磨料射流影响切割诸因素对混凝土试件切割深度的影响。
5) depth face partitioned
深度面分割
6) the depth of taphole
铁口深度
1.
The first,the depth of taphole,its analysis must base on the comprehensive values of some time.
根据济钢1 750 m3高炉炮泥的使用情况,提出了判断炮泥使用效果的标准:铁口深度,应取一段时间内的综合值进行分析,采用铁口深度频率图可以综合判断泥包的情况;炮泥的操作性能,受设备影响较大,采取开口机通水雾化冷却的办法可有效降低开口时间,炮泥生成厂家应根据季节温度变化调整炮泥的马夏值;出铁时间,受出铁间隔时间和高炉上料量的影响。
补充资料:割口增长
分子式:
CAS号:
性质:硫化胶由于外力割伤产生的割口,在周期性变形下割口进一步增大的现象。在割口增长试验中,先在试样上割出一定长度和深度的割口,用德墨西亚屈挠试验机曲挠一定次数后,观察并测量割口增长情况。
CAS号:
性质:硫化胶由于外力割伤产生的割口,在周期性变形下割口进一步增大的现象。在割口增长试验中,先在试样上割出一定长度和深度的割口,用德墨西亚屈挠试验机曲挠一定次数后,观察并测量割口增长情况。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条