1) Short-circuit strength
短路强度
1.
Calculation and Analysis on the Windings Short-Circuit Strength in Large Power Transformers;
大型电力变压器绕组短路强度计算与分析
2.
After summarizing relevant literatures, transient eddy current fields in large transformers and winding short-circuit strength are studied deeply.
本文结合“大型变压器三维瞬态涡流场和线圈短路强度的研究”课题和“变压器运行及事故工况仿真技术研究”课题,在总结有关文献的基础上,对大型变压器的瞬态涡流场和绕组短路强度问题进行了深入的研究,取得了一些具有理论意义与工程实际价值的成果,开发了工程实用的计算软件,为提高变压器绕组的抗短路能力提供了参考依据。
2) strength of resistance to the short circuit
抗短路强度
1.
While selecting the model of the transformers, special attention should be paid on their strength of resistance to the short circuit, security and reliability of insulation, capability to resist to over excitation, as well as whether cooling device, oil storage box, oil tank, sleeve and monitor device have met the standards.
在变压器选型时 ,应特别关注其抗短路强度 ,绝缘的安全可靠性 ,抗过励磁能力 ,以及冷却装置、储油柜、油箱、套管和监测保护装置是否符合标准等。
3) mechanical properties in short circuit
短路机械强度
4) short-term strength
短期强度
1.
The properties of short-term strength and deformation of the two rock salts were analyzed.
分别选定湖北应城盐矿和江苏金坛盐矿为示范工程,通过盐岩单轴压缩试验、三轴压缩试验及巴西劈裂试验,对两盐矿的盐岩试样的短期强度和变形特征进行分析,获得盐岩的短期强度和变形的力学参数。
5) short term strength
短时强度
6) Enhancement mode short circuit
增强型短路
1.
On condition that it is input additional signal , Enhancement mode short circuit will change into cut-off mode short circuit.
短路可分为增强型短路 ,截止型短路和减小型短路 ,在输入附加信号的条件下 ,能变增强型短路为截止型短
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条