1) transmission line method
传输线法
1.
Analysis of shielding effectiveness of rectangular cavity of loaded PCB with aperture by transmission line method;
装有PCB有孔矩形腔屏蔽效能的传输线法分析
2.
Specific contact resistivities(e_c) were measured by transmission line method(TLM) and a lowest e_c of 1.
采用Ti/N i/Au多层金属在高掺杂n型4H-SiC外延层上制作了欧姆接触测试图形,通过传输线法(Transm ission LineMethod,TLM)测量得到的最小比接触电阻为1。
3.
This paper studies a relationship between input impedance and average characteristic impedance (w), wavelength shorten factor(n) and equivalent diameter through analysis of input impedance date of 76m and 138m antenna and proposes a view on the reason for bigger error of input impedance using transmission line method and a correction method.
通过对 76m天线、1 38m天线输入阻抗数据分析 ,对天线输入阻抗与平均特性阻抗、波长缩短系数以及天线等效直径的关系进行了探讨 ,分析了对用传输线法计算天线输入电抗误差较大的原因 ,并对输入电抗的计算提出了修
2) Transmission line method
传输线方法
1.
73×10-5Ω·cm2 measured by the transmission line method(TLM),is obtained through a preheating(350℃,13s) and annealing(400℃,5s)procedure.
在Ｍｇ注入形成的ｐ型ＧａＡｓ材料上，用预热和快速两步退火方式形成ｐ型欧姆接触，用传输线方法（ＴＬＭ）测量比接触电阻，得到最佳值３。
3) transmission circuit method
传输线路法
4) transmission line modeling method
传输线模型法
5) TLM
传输线矩阵法
1.
In the paper, the numerical simulation method for EMC structural design and modeling of electronic devices has been studied in details by TLM ( Transmission-Line Matrix Method ) in electromagnetic field.
本文应用传输线矩阵法,对电子设备的电磁兼容特性的建模和仿真方法进行研究,主要工作有:(1)研究传输线矩阵法建模理论。
2.
Four kinds of simulation arithmetic are introduced in this paper:BCGS-FFT,FDTD,TLM and FEM.
文章介绍了目前四种主要的随钻电阻率测井仪响应模拟算法:BCGS-FFT法、时域有限差分法、传输线矩阵法和有限元法,综合分析了它们各自的特点以及在该领域的应用情况,并展望了随钻电阻率测井仪器响应模拟研究的发展方向。
6) MTL(Model Transmission Line) method
模式传输线法
补充资料：传播常数(见传输线)
传播常数(见传输线)
propagation constant
ChUon匕oChongsh日传播常数(propagation constant)线。见传输
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条