1) conical rod
圆锥形杆
1.
The objective is to present analytical solutions of longitudinal impact analysis for slender conical rods struck by a particle and a new method is proposed for conical rod-particle impact analysis,in which the superposition method is used and the response of the rod is presented.
提出了一种新方法用于分析质点_圆锥形杆碰撞,使用了叠加法给出杆的响应。
2) cone-cylinder screw
锥形-圆柱形螺杆
3) cylindro-conical core
圆柱锥形芯杆(螺杆)
4) conical rod
圆锥杆
1.
A rigid fluid impact model and a normal expansion approximation for calculating impact force are developed,and the dynamic equations for the penetration of a conical rod against half infinite cement target are established by using the theorem of momentum and the law of kinetic energy.
在此基础上，按照动能定律和刚体平面运动微分方程，建立了圆锥杆倾斜侵彻半无限厚水泥靶时的动力学方程，并由此求得撞击力。
2.
The process of stress wave propagation in a conical rod is investigated when the conical rod peretrates against half infinite cement target at an initial penetration velocity among 1000m/s 2000m/s.
研究了初始侵彻速度为 1 0 0 0 m/s～ 2 0 0 0 m/s的圆锥杆对半无限厚水泥靶的垂直侵彻过程及其应力波传播。
5) conical double-screw extruder
圆锥形双螺杆挤出机
6) conical part
圆锥形件
1.
Development of intellectual system for conical part deep drawing;
圆锥形件智能拉深实验系统的研究
2.
This paper had analyzed the deformation feature and essence of conical part in main deformation region (the side\|wall of hang in the air section).
在跟踪金属质点位移轨迹的基础上 ,揭示了毛坯变形区各质点贴模位移与应变间的关系 ,从而明确提出了圆锥形件的成形机理。
3.
A mechanical model of conical part stamping process is built under the conditions of considering thickness variation,anisotropy,work\|hardening,friction factor and so on.
在综合考虑板厚变化、各向异性、加工硬化及摩擦等因素的情况下 ,建立了圆锥形件冲压成形过程的力学模型。
补充资料：Z型圆锥形橡胶减震器
分子式：
CAS号：
性质： 橡胶减震器的一种。外形呈圆锥形。由上下两个倒喇叭形金属骨架中间夹橡胶模压而成。产品三向等频，大变形，结构紧凑，质量轻。用于各种机械、仪表、机床、设备等方面。
CAS号：
性质： 橡胶减震器的一种。外形呈圆锥形。由上下两个倒喇叭形金属骨架中间夹橡胶模压而成。产品三向等频，大变形，结构紧凑，质量轻。用于各种机械、仪表、机床、设备等方面。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条