1) press force
压出力
1.
The result shows that press force and torque of bush-inner plate and pin-outer plate both fall.
结果表明,试验后链条的套筒与内链板以及销轴与外链板之间的压出力和扭矩均有所下降,这就说明了微动磨损现象的存在。
2) extruder pressure
压出压力
3) extrusion pressure
挤出压力
1.
By using the self-amend Tanner constitutive equation, the response of extrusion pressure to vibrating force field in plastic electromagnetism dynamic extruder was studied.
采用自行修正的Tanner本构方程,对塑料电磁动态塑化挤出机中挤出压力对振动力场的响应进行了研究,建立了振动力场下挤出压力响应的理论模型,分析了振动力场作用下挤出压力降低的原因,并从实验方面进行了验证,结果表明,理论分析的结论是基本合理的。
4) discharge pressure
排出压力
1.
Fuzzy control of the discharge pressure of sand pump during refracturing;
重复压裂砂泵排出压力的模糊控制
5) gas outburst pressure
突出压力
1.
Some relationship rules are presented including relationship between gas outburst pressure and maximum velocity of outburst jet,relationship between gas outburst pressure and flow field distribution of gas jet,and relationship between diameter of outburst hole and influence circle of gas jet.
将煤与瓦斯突出过程的瓦斯突出视为连续射流,应用伯努利方程,建立了瓦斯射流的数学模型,得到了瓦斯突出射流流速和流量表达式,在此基础上考虑突出口压力和突出口直径影响,进行了瓦斯射流的数值模拟,得到了突出压力与突出射流最大速度、突出压力与射流流场分布、突出口直径与突出影响范围间关系规律。
6) outgoing station pressure
出站压力
1.
A model to calculate the variation of inter-station pressure drop is established when the on-line buried hot crude oil pipeline is repaired with the sectioning method in the condition of thermo-dynamic stability,by making the computer program in C language,and comparing the difference between excavation and no excavation under the same outgoing station pressure by using examples.
针对原油长输管线在不停输时,由于挖开段的传热系数增大影响到站间的压强,采用分段法在稳定的热力条件下计算不停输原油管道大修时压降,用C语言编制了计算程序;并举例加以说明,对开挖与不开挖时出站压力相同时的压降进行对比分析;确定不出现凝油事故时的最低出站压力。
补充资料：冲击波超压与动压