1) pollutant
污秽物
1.
Combing the graphs for distrbution of polluted parts and pollutants in Shanxi electric power system,we identified the typical pollutant in Shanxi electric network and analysed the components of pollutants,concluding that the main components affecting the normal operation of the network in typical pollutants and accordingly putting forward the guarding measures against certain components.
结合山西电力系统污区分布图及污源分布图,确定山西电网典型污源,并进行污秽物成分分析,得出影响电网安全运行的典型污源中主要成分,并针对某些成分提出防范措施。
2) scales
污秽物系
1.
Therefore such chemical equipment must have the capacity to resist scales,prevent clogging and separate many scales in the equipment.
在化工生产中所处理的物料,有些属于污秽物系,即含有大量固形物及纤维类等物质。
3) non-soluble deposit density
不溶性污秽物质密度
1.
In this paper, the surface pollution deposit law of DC insulator shed, the influence of rainfall on pollution deposit (equivalent salt deposit density, ESDD) and non-soluble deposit density (NSDD), unevenness of pollution between top and bottom surface, du.
利用自建的自然污秽试验站,对自然条件下带直流电压运行2个积污季节的复合绝缘子的积污特点进行了试验研究,分析了直流绝缘子的伞裙表面积污规律、降水对积污(等值附盐密度(equivalent salt deposit density,ESDD)和不溶性污秽物质密度(non-soluble deposit density,NSDD))的影响,表面污秽不均匀度、表面灰盐比、ESDD和NSDD的直交比等。
4) pollution
污秽
1.
Research and application of detecting pollution based on microwave spectrum s performance;
微波波谱特性在污秽检测中的应用研究
2.
The Measurement of Pollution Equivalent Salt Density and Factors Affecting Its Accuracy;
污秽等值盐密的测量及影响其准确度的因素
3.
On the basis of data and anti-pollution technology knowledge,lots of technology research results,such as the correction of SPS,the correction of NSDD and so on should be considered in 800kV UHVDC transmission line external insulation design and arrangement.
针对污秽外绝缘设计是±800kV直流工程关键技术问题之一,提出了对±800kV直流输电线路绝缘子串进行污秽外绝缘设计考虑现场污秽度校正、NSDD校正及采用污耐压方法进行污秽外绝缘设计的方法;根据瓷、玻璃绝缘子的污耐压曲线对±800kV直流输电线路"I"型绝缘子串进行了污秽外绝缘设计。
5) contamination
污秽
1.
Antenna temperature model of insulators contamination detected by radiometer;
辐射计检测绝缘子污秽的天线温度模型
2.
An on-line remote-monitoring system of insulator contamination based on GSM SMS;
基于GSM SMS的绝缘子污秽在线遥测系统
3.
An online monitoring system of insulator contamination;
绝缘子污秽在线监测技术与系统构成
6) contamination condition
污秽状态
1.
Time domain characteristics of leakage current of insulators have been used to forecast contamination condition,but abundant forecast information in frequency components of leakage current has still been ignored.
针对现有染污绝缘子在线检测系统基于泄漏电流时域特征预测绝缘子污秽状态,而忽略了泄漏电流频域成分中含有丰富信息量的问题,提出了利用快速傅里叶变换(FFT)与功率谱估计相结合的分析方法,提取出泄漏电流的2个频谱特征量:3次谐波与基波幅值比κ和功率谱中高频能量与总能量之比α,作为污秽状态预测参量。
参考词条
补充资料：污秽表面放电
| 污秽表面放电 pollution surface discharge 介质表面沾染污秽时所引起的沿面放电。简称污闪。固体介质表面沾染污秽又同时变潮后，污秽层中所含的可溶性盐类和酸、碱等溶于水膜，形成离子电导，使污秽表面通过较大泄漏电流；沿面闪络电压显著降低，严重时能降低到清洁表面闪络电压的10％以下。雾、露、细雨和溶雪天气时，绝缘子甚至会在工作电压下闪络，严重影响电力系统的安全运行。因此，污闪已成为高压和超高压电工设备选择外绝缘水平的主要依据。防止污闪和提高污闪电压的措施有：①定期清扫和用水冲洗绝缘子和绝缘套管。②改进绝缘子结构使刮风、下雨时能自行清扫。③增大泄漏距离，选取合理的泄漏比矩(每千伏工作线电压需要的泄漏距离)。④给绝缘表面上半导体釉或涂硅油等憎水材料。⑤尽量使高压输电线路避开污秽区，避免在污秽区建高压变电所。
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。