说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 闭室测试
1)  closed chamber test
闭室测试
1.
From the formula of reaction exothermic rate, the differential equation of C(t) in the closed chamber test is given.
给出了气敏元件反应放热率Prea的公式,并由此给出在闭室测试中气体浓度C随时间变化的微分方程。
2)  Airtight testing
密闭测试
3)  closed-loop test
闭环测试
1.
Hypersim-based closed-loop test environment for substation automation system;
基于Hypersim的变电站自动化系统闭环测试环境的建立
2.
A general method of intelligent controller design and closed-loop test based on VHDL and FPGA implementation is proposed.
提出了一种基于VHDL描述、FPGA实现的智能控制器设计和闭环测试的一般性方法。
4)  Close Loop Test
闭环测试
1.
The simulation and test results indicate that the modeling is feasible and valid, which can fully and factually reoccur the power quality problems produced by arc furnace, such as voltage fluctuation and flicker, harmonics and unbalances, and the test system based on RTDS can be used for close loop testing of SVC controller.
在此基础上,本文还根据实际电弧炉配电系统,搭建了用于静止无功补偿(SVC)系统控制和保护设备闭环测试的实时仿真系统(RTDS)并进行了控制器闭环测试。
5)  test room
测试室
1.
The Air-conditioning & Ventilation system in high-low Temperature test room;
某发动机高低温测试室空调及通风设计
2.
Research on performance test room of certain refrigeration compression condensing unit;
制冷压缩冷凝机组性能测试室研究
6)  Measuring indoor air temperature
室温测试
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条