说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 列检
1)  train inspection
列检
1.
According to the necessity of heavy haul, speed increase of freight trains, the suggestion about adjusting the layout of the freight train inspection is put forward.
根据货物列车重载、提速的需要 ,提出了关于调整货车列检作业布局的建
2.
The computer real time monitoring and management system in freight train inspection is described.
介绍了由工业控制计算机、PL C可编程控制器、单片机和无线遥控设备以集中和分布式网络相结合的方式构成的货车列检作业计算机实时监控与管理系统 ,对其软硬件设计和应用前景进行了论述。
2)  goods train inspection distribution
列检布局
3)  freight train examination
列检作业
1.
One of the ways to raise train speed and transport efficiency is to prolong time interval and extend safety section of freight train examination.
增大列检作业间距,延长列检安全保障区段,是提高铁路列车运行速度和运输效率的主要方法之一。
4)  queue detection
队列检测
1.
The queue detection algorithm described here consists of a motion detection and vehicle detection operation.
提出的队列检测算法包含运动检测和车辆存在检测,通过合理分配使用这两种操作,节省了运算时间。
5)  sequence detection
序列检测
1.
A low-complexity sequence detection algorithm for CPM
一种低复杂度的连续相位调制序列检测接收机
6)  sequential detection
序列检测
1.
In this paper, three kinds of typical sequential detection methods are presented and modified based on radar polarization information, and the performances of these three modified methods in phased array radar are analyzed in details.
在相控阵雷达中采用序列检测可提高雷达信号检测性能和改善数据率 ,本文利用雷达极化信息对三种典型序列检测方法进行了改进研究。
2.
Based on weapon locating radar,this paper discusses detection performances of itssequential detection system in detail firstly.
以某型炮位侦察校射雷达为实际工程背景,详细讨沦了其序列检测系统的检测性能,并应用最优化方法得出其最佳门限和最佳判定准则。
3.
Based on the single detection,the decision fusion is introduced and the sequential detection based on fuzzy decision fusion is build.
基于贝叶斯最小风险准则建立分布式决策模糊融合方法,有效融合单帧检测的结果,提高序列检测算法的性能。
补充资料:光二极管阵列检

是利用光二极管阵列检测器对光子进行检测。光二极管阵列检测器是一种对光子有响应的检测器。它是由硅片上形成的反相偏置的p-n结组成。反向偏置造成了一个耗尽层,使该结的传导性几乎降到了零。当辐射照到n区,就可形成空穴和电子。空穴通过耗尽层到达p区而湮灭,于是电导增加,增加的大小与辐射功率成正比。光二极管阵列检测器每平方毫米含有15000个以上的光二极管。每个二极管都与其邻近的二极管绝缘,它们都联结到一个共同的n型层上。当光二极管阵列表面被电子束扫描时,每个p型柱就连接着被充电到电子束的电位,起一个充电电容器的作用。当光子打到n型表面以后形成空穴,空穴向p区移动并使沿入射辐射光路上的几个电容器放电。然后当电子束再次扫到它们时,又使这些电容器充电。这一充电电流随后被放大作为信号。光二极管阵列可以制成光学多道分析器。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条