1) load critical depth
荷载临界深度
1.
It is found that the load critical depth and the friction range increase while the cap breadth increases with the same r.
发现置换率相同时,承台板宽度大,水泥土桩的荷载临界深度也大,桩侧摩阻力分布深度下移。
2) critical load and length
临界荷载和长度
3) critical load
临界载荷
1.
Study on critical load and elastic stability of drilling riser;
钻井隔水导管临界载荷及弹性稳定性研究
2.
A calculating method of critical loading for dual-extension hydraulic legs of hydraulic powered supports;
液压支架双伸缩立柱临界载荷的计算方法
3.
Supporting-displacement-based critical load calculation for jib strings of rubber tired gantry cranes;
支座位移对轮胎式起重机臂架弦杆临界载荷的影响
4) critical load
临界荷载
1.
Analysis of critical load for lateral buckling of beam;
梁侧向屈曲临界荷载分析
2.
Lateral-torsional buckling critical load under the effect of I-type member s transverse concentrated load;
Ⅰ形构件横向集中荷载下的弯扭屈曲临界荷载
3.
Study of critical loads of thin-walled cylinder pressure vessel with crack;
带有裂纹的薄壁圆筒压力容器临界荷载研究
5) critical loads
临界载荷
1.
According to the thin shell plastic stability theory, based on the plastic instability coefficients and energy rule,the theoretical for calculating critical loads of plastic wrinkling on the ends of the hydroformed tube is establ.
通过将基于塑性失稳系数的薄壳塑性稳定性理论与能量准则相结合,在系统势能极小条件下,建立起薄壁管无模内高压成形端部塑性皱曲临界载荷的理论计算方法。
2.
The first three critical loads and corresponding bifurcation solutions are calculated.
利用非线性有限元方法，研究了具有中心弹簧支承的极正交各向异性圆板的稳定性问题，计算了前三个临界载荷（分支点）和相应的分支解，得到了过屈曲状态的大泛围响应，发现由于弹簧约束过屈曲模态变化的现象，并预测了二次屈曲的可能
3.
The buckling critical loads are obtained with varying holes.
将强激光对一种飞航导弹舱段模拟件蒙皮的作用简化为烧蚀形成不同尺寸的孔洞,采用有限元程序计算了模拟件的弹塑性屈曲过程,得到了不同大小孔洞下的屈曲临界载荷。
6) critical loads
临界荷载
1.
Calculation method on buckling critical loads for welding aluminum alloy beam;
焊接铝合金梁的稳定临界荷载计算方法
2.
The modes of instability and the critical loads at critical condition are obtained.
本文应用非线性有限元法对球壳、扭壳、双曲扁壳和马鞍形壳在不同矢高情况下进行屈曲分析，获得了临界状态下的失稳模态和临界荷载。
3.
If these elastic restraints action of buckling resistance is taken into account the critical loads of steel members may apparentely been increased and plenty of steel material is saved.
利用连接构件之间约束作用，钢构件的稳定临界荷载可以得到显著的提高，节约大量的钢材。
补充资料：地下水临界深度
地下水临界深度
critical depth of subsurface water
dixia蜘山11邸e台hendu凳霉羹护影孽一呼客缀靡谧热〕:薰翼节耀乓缪降苹万表二刀沁干刁万孙级淤蒸发量剧烈增加。毛管水强烈上升高度:轻质土为鑫欲如反一临所:熏黔热二i溯…薰鳞!黔释攀鑫鬓节礴群料拼酱中国j要盆渍上池区地下水临界深度表┌────┬────┬──────────────────┐│{_ │_地下水 │一地下扣质事碑琢、来戈_ ││ │矿化度 ├────┬──────┬──────┤│ │咚/1+卜 │择博后干│竺唇苦- │…邻再锡_ ││ │ ├────┤ │_的麟舞每士 ││ │ │巴 │ │ ││ │ │一、- │ │ │├────┼────┼────┼──────┼──────┤│_{啡一_ │l一3 │卜8~红2 │一卜。祖一哥│一毛针七“_ ││ ├────┼────┼──────┼──────┤│ │ )3厂 │2.1一今3│l.2二价- │ 王.吕一2.0││ │ │ │ │ │├────┼────┼────┼──────┼──────┤│朴亨_ │10左右 │么5左右 │二一 │一_上6一2一2││ ├────┼────┼──────┼──────┤│ │一_)加 │》2巧一 │_二 │2.4一2.6_ │└────┴────┴────┴──────┴──────┘(衰妹极一亥生有昌)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条