2) current waveform output
电流波形输出
3) output voltage ripple
输出电压纹波
1.
Making these systems worked on chaotic state can reduce EMI,but may induce higher output voltage ripple.
利用混沌能够降低开关模式电源的EMI(Electromagnetic interference),但会引起较大的输出电压纹波。
2.
Effects of output voltage ripple on the stability of current-mode Boost converters is studied in this paper.
研究了电流型Boost变换器输出电压纹波对变换器稳定运行的影响。
3.
System control mode is simple,using input current limiting technique to keep output voltage ripple below 50 mV,adopting multi-topology switch-capacitor array and gain hopping to obtain the average efficiency above 60% and peak efficiency above 85%.
系统控制模式简单,采用输入限流使输出电压纹波控制在50 mV以内,采用多种模式的开关电容阵列以及增益跳变提高传输效率,得到60%以上的平均效率,85%以上的峰值效率。
4) output ripple voltage
输出纹波电压
1.
The output ripple voltage(ORV) in each mode is analyzed respectively,and the maximum value of ORV(MORV) is.
对3种模式的输出纹波电压进行了分析,得出了最大输出纹波电压。
2.
To reach the desired output ripple voltages (ORV) of a Buck DC/DC converter with a rather small inductance and especially to meet the requirements of the intrinsic safety, the operating region of the converter is divided into four parts on the input-voltage versus load plane according to the inductance of its inductor.
为使Buck变换器以较小的电感达到期望的输出纹波电压指标并满足本质安全要求,在输入电压?负载构成的平面上,按电感的取值将Buck变换器划分成四个工作区域,求出其在各个区域的输出纹波电压极大值;指出在变换器输出电流最大的情况下,如果电感的取值使得变换器在输入电压最低时处于连续导电模式(CCM),而在输入电压最高时处于不连续导电模式(DCM),则输出纹波电压极大值最高;最小负载电阻和最高输入电压所对应的CCM和DCM的临界电感,即为整个工作范围内使输出纹波电压极大值最低的最小电感。
5) waveform output
波形输出
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条