1) Fatigue fracture of teeth
疲劳断齿
2) tooth root fatigue
齿根疲劳
1.
Helical and spur gears were used in the study where the densification as well as the resulting gear quality and tooth root fatigue was tested.
在研究中所用的螺旋齿轮与正齿轮,对致密化及所得到的齿轮的质量与齿根疲劳都进行了试验。
3) fatigue fracture
疲劳断裂
1.
Calculating method of reliability on anti fatigue fracture of weld;
焊缝材料抗疲劳断裂的可靠性计算方法
2.
An Analysis on Fatigue Fracture of Oil-Suck-Rod of Non- Quenching and Tempering Steel;
非调质钢抽油杆疲劳断裂的分析
3.
The causes of fatigue fracture of cage in high speed ball bearing;
高速球轴承保持架疲劳断裂原因分析
4) fatigue fracture
疲劳断口
1.
Fatigue Fracture Morphology and Crack Propagation Mechanism of Die Cast AZ91 Alloy;
压铸态AZ91镁合金疲劳断口组织与裂纹扩展机制
2.
On the base of the fatigue small cracks growth test in TA6V titanium alloy,the fatigue fracture of TA6V titanium alloy SENT specimen is analyzed.
在进行TA6V钛合金疲劳小裂纹实验的基础上,使用KYKY2800B型扫描电镜(SEM)对TA6V钛合金疲劳断口形貌进行疲劳源区及其裂纹扩展形状、扩展区、瞬断区形貌的观察,分析TA6V钛合金疲劳断口形貌形成的原因,为其结构疲劳安全设计及可靠性分析提供科学依据,为今后TA6V钛合金在我国的使用提供参考。
3.
Influence of rare earth elements on high-cycle fatigue properties of AZ91D alloy was investigated and the fatigue fracture morphology was also analyzed.
研究了稀土元素对AZ91D压铸镁合金高周疲劳性能的影响,并对疲劳断口的组织形貌进行了分析。
5) fatigue crack
疲劳断裂
1.
The producing of fatigue cracks and fracture in the ultrafine-grained(UFG) and coarse grained(CG) Cu-0.
6Cr合金的驻留滑移带非常杂乱,超细晶铜铬合金的剪切带沿着ECAP最后一道次剪切面发展,沿着ECAP最后一道次剪切面发展的剪切带在疲劳断裂初期和早期的裂纹增殖中起着决定性作用。
2.
From these responses,the fatigue crack cycle life of road was calculated.
为研究公路车辆对道路的破坏性,采用功能化虚拟样机(Functional Virtual Prototype)技术,基于多体系统动力学理论建立车辆系统的功能化虚拟样机,通过仿真得到车辆对道路的动态作用力;采用有限元方法(FEM)进行道路响应的研究,继而进行道路的疲劳断裂分析。
6) fatigue failure
疲劳断裂
1.
The analysis result indicates that the property of the piston failure is fatigue failure and the failure initiation is the cutting trace on the root face of the U trough.
采用扫描电镜等手段分析了断裂活塞，结果表明活塞断裂的性质属于疲劳断裂。
2.
By analysis of the forces acting on the up and the down roller axles of the pinch roller,the cause of the up roller axle fatigue failure but the down roller axle not was found out and the improvement method was given on condition that the material and making process of the up and the down roller axles were sam
通过对送料机夹送辊上、下辊轴的受力分析，找出了在上、下辊轴材料和加工工艺相同条件下，上辊轴发生疲劳断裂，而下辊轴不发生疲劳断裂的原因，并提出解决措施。
3.
Earlier fatigue failure phenomenon of SOFIM Engine connecting rod bolt is concentrated on in this paper.
针对SOFIM连杆螺栓出现的早期疲劳断裂现象,建立了连杆螺栓的有限元模型,利用ANSYS软件对该连杆螺栓进行了有限元分析,并与疲劳试验结果进行了对比,吻合较好。
补充资料：齿（齿所）
齿（齿所）
齿（齿所） 病名。系指牙齿被醋浸渍的病证。《诸病源候论》卷二十九：“齿（齿所），齿伤酢也。齿者骨之所终，髓之所养，髓弱骨虚，风气客之，则齿（齿所）。”酢，同醋。参见齿齼条。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条